Craftsman 486.24517 againstcrossbraceSecuretopofdoorusingdoor, inthesidesofthecart.Seefigure15

25.Assembleashorttarpstrapto reardoorusingone 1/4"x 1-1/4"hexbolt,two1/4"flatwashersandone 1/4"nylocknut.Assemblean"S"hookthroughloose endofstrap.Seefigure15.Repeatonothersideof door.

26.Assembledoorto rearof cartbyrestingbottomof doorondoorsupportsandpushingtopof doorin

againstcrossbraceSecuretopofdoorusingdoor.

latchesoneachside.Seefigure15. 27.Hookboththetarpstrapsontothe1/4"x 1"hexbolts

inthesidesofthecart.Seefigure15.

DOOR LATCH

1/4" x 1-1/4" HEX BOLT

1/4" FLAT WASHER

STRAP (SHORT)

1/4" FLAT WASHER

	DOOR
1/4" NYLOCK NUT	SUPPORTS

1/4" x 1"

HEX BOLT

FIGURE 15

28.Attach the engine/impeller housing assembly to the upper holes in the angles welded to the tongue. Use four 5/16" x 3/4" hex bolts and 5/16" nylock nuts. Tighten. See figure 16.

5/16"

NYLOCK NUT

5/16" x 3/4"

HEX BOLT

WELDEDFRONT_

ANGLES_ONGUE

FIGURE 16

29.Remove the hex bolts and nylock nuts from the two holes in the impeller housing shown in figure 17. Assemble the hose hanger bracket to the impeller

housing using the bolts and nylock nuts which you removed.

USE THESE

HOLES

HOSE

HANGER

)

BRACKET

USE PRE-

BOLTS AND

NYLOCK

NUTS

FIGURE 17

30.Assemble the elbow to the impeller housing using four 5/16" x 3/4" self tapping hex bolts and four nylon washers. Push while turning to help start the bolts into the unthreaded holes. Tighten. See figure 18.

31.To center the elbow with the opening in the hard top:

a.Push the vinyl boot back inside the opening.

b.Loosen by approximately 1/4 turn each, the four bolts that you assembled in figure 16.

c.Push against the elbow to center it with the sides of the opening.

d.Retighten the four bolts that you loosened.

32.Pull the vinyl boot onto the end of the elbow.

Center elbow between

aides of opening

\

NYLON

WASHER

HEX BOLT I	'_-_.'-
(Thread Forming)	G_ ....
	Looae_n4_( _a
I	114turn each %,, ,

FIGURE 18

12