ASSEMBLY

Tools Needed:

(2)1/2" Open End Wrench

(1)Hammer

*Refer to Illustrations on page 3.

(See Figure 1)

1.Insert one Round Flange Bearing(16) into the hole in the End Cap(5), and insert End Cap(5) into one end of the Striper Tube(1).

2.Slide the Axle(3) through the Round Flange Bearing(16) leaving roughly 3" of axle outside the End Cap. Place one Washer(12) over the end of the axle.

3.Insert one Hex Flange Bearing(11) into the hole in the Hitch Tube(6), and slide the Hitch Tube over the axle. The bearing flange must face against the washer.

4.Using a Hammer, tap one 1/2" Palnut(13) over the end of the Axle(3), until it is fully seated.

(See Figure 2)

5.Place the unit in an upright position and fill the Striper Tube(1) with sand. Leave about 1" of the tube un-filled.

(See Figure 3)

6.With the unit still standing on end, insert one Round Flange Bearing(16) into the hole in the End Cap(5), and insert End Cap(5) over the axle, until it is fully seated in the Striper Tube(1).

7.Place a Washer(12) over the end of the axle.

8.Insert one Hex Flange Bearing(11) into the hole in the Hitch Tube(6) and slide the Hitch Tube over the axle. The bearing flange must face against the washer.

9.Using a Hammer, tap one 1/2" Palnut(13) over the end of the Axle(3), until it is fully seated.

10.Carefully lay the unit down and place the Scraper Bar (2) on top of the Hitch Tubes(6) and secure to each end with one 5/16" x 1-3/4" Hex Bolt(9) and one 5/16" Nylock Nut(15). Make sure both bolts are tight.

(See Figure 4)

11.Place two 5/16" x 2-1/2" Hex Bolts(7) through the Hitch Tubes, and secure with two 5/16" Nylock Nuts(15).

DO NOT FULLY TIGHTEN THE NUTS AT THIS TIME.

12.Place two 5/16" x 2-1/4" Hex Bolts(8) through one of the Hitch Brackets(4). From the top, slide the bolts between the two Hitch Tubes, making sure the Bracket Bolts(8) are in between the Tube Bolts(7).

13.Place the other Hitch Bracket(4) on the bottom of the Hitch Tubes and secure with two 5/16" Nylock Nuts.

TIGHTEN ALL BOLTS.

OPERATION

1.Attach the Lawn Finisher behind any Lawn and Garden tractor, with one Hitch Pin(10) and one Hairpin Cotter(14).

2.Tow in a "back and forth" manner across your yard, to create the desired look. This unit can be towed while mowing.

SPECIFICATIONS

Roller Length

48"

Roller Dia.

4"

4