Place the loosely assembledframe onto the rear of
the b'actor,hookingthe notched ends ofthe mounting
bracketsunder the shoulderbolts, Attachthe hitch
bracketto the tractor hitchusingthe clevis pin and a
1/8" hairpinclip. See figure6.
Alignthe frame so that it is straightand level withthe
tractor.Tighten thefour 5/16" x 3/4" hex bolts
(assembled infigure 4) whichfasten the mounting
bracketsto the hitch bracket.
Slide the 3/8" x 1"hex bolts alongthe hitch bracket
slotsuntilthey are bumped upagainst the backedge
ofthe tractor hitch.Tighten. See figure 6.
Place the toolbox onto the frame so thatthe heads
ofthe shoulder boltsin the bottom of the toolbox fit
down intothe keyholeslots. Slide the tool box
forward,slightlytilting up the back end, untilthe
clevispins in the bottomof the tool box drop down
intothe holes at the rear of the frame. Secure the tool
boxto the frame with two 1/8" hairpinclips through
the clevis pins. See figure 7.
Tighten the two bolts (assembled in figure 5) which
fasten the brace strap to the mountingbrackets.The
strapkeeps the frame at the correctalignment width
when removingand reattachingthe frame and the tool
box.
3/8" x 1"
HEXBOLT'-----. I I
IItSHOULDER
BOLT
F 6

[o]"J=1: ,JIII

&CAUTION: Vehicle braking and stability
may be affected with the addition of an
accessory or en attachment. Be aware of
changingconditions on slopes.
Engage the tractor clutch smoothlywhert starting
the tractor in motion. Sudden, full throttle starts
could cause the front end of the tractor to lift off the
ground, causing loss of steering control.
Fill the Trac Pack with up to 100 pounds of material
or tools.
Do Not exceed the 100 poundweight capacity of
the Trec Pack.
To remove the tool box from the Trac Pack frame,
'remove the 1/8" hairpin clips from the two clevis pin
inthe bottom of the toolbox. Lift up the rear ofthe
tool boxenough to raise the pinso,t ofthe frame
end then pull back and uptO remove the heads of
the shoulder bolts from the slots in the frame.
To remove the Trac Pack frame from the tractor,
remove the 1/8"hairpin clipend the clevispin from
the hitch bracket. Unhook the frame from the
shoulder boltson the sides of the tractor and
remove the frame. The shoulder bolts may be left
permanently attached.
Rinse or wipe off the Trac Pack after each use.
Do not store with material in the tool box. Store inside ina clean, dryarea.