OPERATION
Become familiar with all of the controls and adjustments on the Power Rake before operating. Controls for operating Power Rake are as follows:
SAFETY SWITCH - Must be pressed in before handle switch can be used to start motor.
HANDLE SWITCH - Pull and hold to start and keep motor running. When let go motor will stop and safety switch should
POWER CORD - Supplies electricity to the Power Rake, make sure to connect to a power supply using only outdoor rated extension cables.
CORD HOLDER - Holds extension cord to help keep it out of the way and take stress off of the handle switch cord.
CORD
HOLDER
HANDLE
SWITCH
SAFETY
SWITCH
EXTENSION
CORD
/_OWER
ORD
CORD
HOLDER
EXTENSION | CORD | RATINGS |
|
|
(Use only outdoor rated extension cords plugged into a |
| |||
ground fault | receptacle.) |
|
| |
GAUGE | LENGTH |
| ||
16 Gauge | 0 - | 50 Feet |
| |
14 Gauge | 51 - | 100 Feet | FIGURE 7 | |
MAINTENANCE
CAUTION: BEFORE PERFORMING
ANY MAINTENANCE, MAKE SURE
THE POWER RAKE IS TURNED OFF
AND UNPLUGGED FROM ANY POWER
SOURCE.
Clear excess debris left in Power Rake housing after each use.
Make sure nothing has wrapped around the tines/ tine shaft. Remove anything that has wrapped itself around the tines/tine shaft.
Check and make sure all wing knobs and carriage bolts are tightened.
•Clean Power Rake and bag before storing. Do not clean with water, solvents or petroleum based products.
•Store in a dry place that is not exposed to the elements and out of the reach of children.
6 | Call |
| DO NOT RETURN TO STORE |
