Craftsman 580.751651 owner manual Assembly, Checklist, Fig

ASSEMBLY

• Attach wire support to two lower holes in guide handle			Screen in water inlet for cleanliness and inspect Inlet
			Screen on female connector. Reattach male connector
with # 10 self-drilling screws and # 10 fiat washers (Fig.
			to water inlet and attach female connector to garden
3). The hose minder should be to the left and gun holder
			hose.
to the ri_ht. Be sure loop of support is pointing upward.
Place vmyt cap onto gun holder.		•	Unravel high pressure hose, remove protective cap
	I		from end of hose and check other end of hose to see
			that threads are properly covered with teflon tape. If
			tape is not properly applied, reapply it so threads are
VINYL CAP			fully covered. The tape seals the connection from hose
			to gun and wand assembly.
			Attach fitting with teflon tape to gun and wand assembly
			(Fig. 6). You may want to spin gun. Tighten with adjust-
			able wrench to keep hose from twisting.

GUIDE

/HANDL_

/

WIRE

SUPPORT

FIG.3

TO ASSEMBLE REMAINING COMPONENTS

IMPORTANT: YOU MUST ASSEMBLE WAND AND AT- TACH ALL HOSES BEFORE YOU START ENGINE. STARTING ENGINE WITHOUT ALL HOSES CON- NECTED AND WATER SUPPLIED WILL DAMAGE PUMP,

•Remove cap from top of pump and insert oil fill cap attached to other end of yellow waming

tag,•

FIG. 4

Included with this unit is a Quick-Connect fitting you attach to Water Inlet on pump, The quick-connect includes two parts -- a Male Connector factory-in- stalled on water inlet and a Female Connector (Fig. 5). Remove male connector to inspect Intake Supply

INTAKE SUPPLY OPENING

_R'AKESUPPLY FILTER

FEMALECONNECTOR

MALE

INLET SCREEN

FIG. 5

FIG. 6

Attach the other end of the high pressure hose to high I pressure fitting on pump (Fig. 7). Tighten with adjust-

abte wrench.

DETERGENT PICKUP TUBE

HIGH PRESSURE

HOSE

FIG. 7

,,Attach Detergent Pickup Tube and Filter as shown in Fig. 7.

oTo attach the adjustable nozzle, refer to Operation section, Fig. 9,

CHECKLIST

•Check that fasteners you used to install wheels and handle are tight. Vibration during operation may loosen fasteners that are not tight enough,

•Check for proper hose connections (high pressure and water supply) and for tight connections and that there

are no kinks, cuts, or damage to the high pressure hose.

o Provide proper water supply (not to exceed 140°F).

•Be sure to read "Safety Rules" and "Operation" se_ tions before using the pressure washer,