chemicals, wear approved safety equipment such as dust masks that are specially designed to filter out microscopic particles.
WARNING: This product contains chemicals, including lead, known to the
State of California to cause cancer, and birth defects or other reproductive harm. Wash hands after handling.
SAVE THESE INSTRUCTIONS
ASSEMBLY INSTRUCTIONS
ASSEMBLY
WARNING: To avoid serious injury, make sure that the tool is switched off and unplugged before assembly.
FITTING THE GUARD (FIG. 1)
•Remove the screw (17) from the guard (10).
•Place the guard onto the tool as shown.
•Firmly press the guard until it snaps into place.
•Secure the guard with the screw.
WARNING: To avoid serious injury, never use the tool unless the guard is properly fitted.
FITTING THE SECONDARYHANDLE (FIG. 2)
•Place the handle (5) on the tool as shown.
•Adjust the handle to the most comfortable position. Use the markings as a guide.
•Pass the bolt (6) through the secondary handle and the main handle.
•Screw the bolt into the far side of the secondary handle. Do not overtighten the bolt.
STORING THE CASSETTE NOT IN USE (FIG. 3)
The tool has two cutting system cassettes:
•AFS: Autofeed System twin line for light trimming and edging.
•HDL: Heavy Duty Line cutting system for more overgrown areas.
The cutting system cassette not in use can be stored in the position provided (16).
•Align the tabs on the cassette with the cut outs (28) at the underside of the handle.
•Push the cassette into the handle until it snaps securely into place.
STORING THE HEAVYCUTTING LINE (FIG. 3)
•The unit is supplied with several pieces of spare heavy cutting line.
•The extra pieces of heavy cutting line can be stored securely in the recess in the handle (14).
1 |
|
17 | 10 |
| |
2 |
|
5 |
| |
| 6 | |
3 |
| |
28 | 14 | |
16 | ||
| ||
| 19/25 |
RELEASING THE CUTTING LINE
For shipment purposes, the cutting line is taped to the spool housing.
•Remove the tape holding the cutting line (13) to the spool housing (12).
CONNECTING THE TOOL (FIG. 4)
•Connect the female plug of a suitable extension cord to the power inlet (4).
•Loop the cord through the cord restraint (3).
•Insert the plug into a receptacle.
5
