-Temporarily park the line in the holding slots (23) on one side of the spool as shown in the inset in Fig. 11.
•Repeat the above procedure for the second cutting line on the lower section of the spool.
•Fit the spool onto the tool as described in Fitting a New Spool of Cutting Line.
CAUTION: Before you begin trimming, only use the appropriate type of Craftsman cutting line. Ensure that cutting line is present in both sections of the spool. Fig. 9.
10
11 |
|
24 |
|
23 | 23 |
12 |
|
25 |
|
| 28 |
27 | 26 |
FITTING THE HDL CASSETTE (FIG. 12) Your trimmer is shipped with the AFS cassette installed. To fit the HDL (Heavy Duty Line) cassette, proceed as follows:
•Unplug the tool.
•Keep the tabs (18) depressed and remove the AFS cassette (19) from the cassette housing (12) in the trimmer head. Fig. 8.
•Make sure a piece of heavy cutting line is correctly fitted to the HDL cassette, as described in Fitting a New Piece of Heavy Duty Cutting Line below. Fig. 12.
•Align the tabs on the HDL cassette with the slots (22, Fig. 8) in the cassette housing.
•Push the HDL cassette into the housing until it snaps securely into place.
FITTING A NEW PIECE OF HEAVY DUTY CUTTING LINE (FIG. 12) Replacement pieces of heavy duty cutting line are available from your Craftsman dealer (item. no. 85876). To fit a new piece of cutting line, proceed as follows:
•Unplug the trimmer from its power source.
•Depress the tabs (28) and remove the HDL cassette (25) from the cassette housing (12, Fig. 8) in the trimmer head.
•Remove the used piece of line from the cassette.
•Remove any dirt and grass from the cassette and housing.
•Thread a new piece of line (26) through the holes in each side of the cassette.
•Place the metal ferrule (27) in position as shown.
•Align the cassette tabs with the slots (22, Fig. 8) in the housing.
•Push the cassette onto the housing until it snaps securely into place.
8
