PLUGGING UNIT ASSEMBLY
Refer to Fig. 4
•Identify the two Outer Tube Assemblies (13- has one plate welded close to end of tube) and the Center Tube Assembly (14- has both plates welded close to end of tube).
•Insert the Axle Assembly (11) partially through hole in Side Plate (6) at RI.._HTSIDE.
•Install as follows:
• 3/4" Flat Washer (29),
eOuter Tube Assembly (13)- with short Hub end next to Right Side Plate.
•3/4" Flat Washer (29).
•Center Tube Assembly (14).
•3/4" Flat Washer (29).
•Outer Tube Assembly (13) with short Hub end next to Left Side Plate.
•3/4" Flat Washer (29).
_:Make sure Nylon Bearings are inside Tube Assemblies. See Fig.3.
•Align Axle Assembly shaft end with hole in Left Side Plate and push through as far as possible. Slide on a 3/4" Flat Washer (29).
•Install Lift Handle Assembly (12) over Axle
Assembly Shaft- Welded Tube on Lift Handle | Fig. 4 |
FACING OUT. |
|
•Position strap on Axle Assembly (at opposite side) in line with short end extending from Lift
Handle (with Wheel mounting holes) and align holes in Handle Tube and Axle Shaft. Insert a
•Slip Handle Grip (15) over end of Lift Handle. NOTE: Soapy water will ease this assembly.
TRANSPORT | WHEELS |
|
|
Refer to | Fig.5 |
|
|
• |
|
| |
using |
|
| |
(28) next to Bolt Head through Wheel Hubs |
|
| |
(opposite extended Hub side). |
|
| |
• Install a Flat Washer (28) | next to Hub and 1/2" | 23 | 28 |
Hex Nut (25) threaded on as far as possible with |
| ||
|
| ||
Bolt still free to turn. |
|
|
|
• Install both Wheels through holes in Side Straps |
| 28 | |
|
| ||
( 11 & 12) securing with Lock Washers (26) and Hex |
|
| |
Nuts (25). Tighten securely, | but with Wheels free to |
| Fig. 5 |
turn. |
|
|
|
•Check all fasteners for tightness. Your Aerator is now ready for use.
