VACUUM ASSEMBLY
NOTE: Assembly instructions for using your unit as a blower are explained in the previous section.
If you have already assembled your unit for use as a blower, remove the blower tube.
Remove the inlet restrictor
An inlet restrictor is used when using your unit as a blower. This restrictor is not used during vacuum use and must be removed during assembly for vacu- um use.
NOTE: Be sure to keep the inlet re- stricter for using your unit as a blower.
1.Ensure unit is stopped and extension cord is unplugged.
2.Open the inlet cover by inserting the tip of a screwdriver into the latch area on the blower unit. Gently tilt handle of screwdriver toward the front of the unit to release the latch while pulling up on the vacuum inlet cover with your other hand.
ground during vacuum use. The lower tube attaches to the upper tube.
1.Ensure unit is stopped and exten- sion cord is unplugged.
2.While holding inlet cover open, place the hooks of the vacuum assist han- dle on the retaining posts of the unit.
VacuUPmPeArsVUH , T: be
3.Pivot the tube until it is secured to
the blower unit by the red inlet cover latch.
Bottom view | Latch Area |
of unit
Vacuum Inlet Cover (closed)
Latch Area
4.Attach the lower vacuum tube to the
upper vacuum tube by aligning the arrows on the two tubes. Press the
tubes together until the lower tube is fully seated in the upper tube.
(About 3 inches)
ube Lower Tube
|
|
|
|
| i"_ | ........... , | |
Vacuum / nlet | Cover | (opened) | _'_ | Align arrows on upper | |||
3. Turn the inlet restrictor counterclock- | i_ | and lower tubes | |||||
wise and remove it from the unit. Do | COLLECTION BAG ASSEMBLY | ||||||
not close the inlet door. You will next | |||||||
1. Open the zipper on the collection | |||||||
attach the vacuum | tubes. | ||||||
bag and insert the elbow tube. | |||||||
| \ |
|
| ||||
|
| Vacuum2. Push the small end of the elbow | |||||
\ | ,_ | _ | Inlet Cover | tube through the small opening in | |||
the | bag. |
| |||||
|
|
|
|
| |||
|
|
|
| NOTE: | Make sure edge | of the small | |
Inletri__
Restrictor
Attaching the vacuum tubes
There are 2 vacuum tubes, an upper
tube and a lower tube. The upper tube has a vacuum assist handle attached
to one end and is cut straight on both
ends. The upper tube attaches to the blower unit. The lower tube has an angled end that you point toward the
opening is flush against the flared area of the elbow tube and the hole for the
tube release button is on top.
Elbow Tube | Tube |
/ | Release |
| Button |
| Hole |
Zipper |
|
Opening | Opening |
|
6
