Owner's Manual | Model No. 875. f99340 |
Owner's Manual | Model No. 875.199340 |
Tool runs slow or will not operate.
Moisture blowing out of tool
1. Grit or gum in tool | 1. Flush the tool with air tool oil, gum | |||
|
| solvent, or an equal mixture of SAE 10 | ||
|
| motor oil and kerosene. Lubricate the tool | ||
|
| after cleaning. |
| |
2. No oil in tool | 2. Lubricate the tool according to the | |||
lubrication instructions in this manual. | ||||
|
| |||
3. Low air | pressure | 3a. Adjust the regulator on the tool to the | ||
maximum setting (If applicable). | ||||
|
| |||
|
| 3b. Adjust the compressor regulator to tool | ||
|
| maximum while the | tool is running free. | |
4. Air hose | leaks | 4. Tighten and seal | hose fittings if leaks are | |
|
| found. |
| |
5. Pressure | drops | 5a. Be sure the hose is the proper size. | ||
Long hoses or tools using | ||||
|
| |||
large volumes of air may require a hose with an I.D. of 1/2" or larger depending on the total length of the hose.
5b. Do not use multiple number of hoses connected together with quick connect
fittings. This causes additional pressure drops and reduces the tool power. Directly
|
| connect | the hoses | together. |
| |||
1. Water | in tank | 1. Drain tank. (See air compressor manual). | ||||||
Oil tool | and run until no water | is evident. Oil | ||||||
|
| tool | again | and | run | |||
2. Water | in the air lines/ | 2a. | Install | a water | separator/filter. | |||
hoses |
| NOTE: | Separators | only work | properly when | |||
|
| the air passing through the separator is | ||||||
|
| cool. Locate the separator/filter as far as | ||||||
|
| possible | from the | compressor. |
| |||
|
| 2b. Install an air dryer. |
| |||||
|
| 2c. Anytime water enters the tool, the tool | ||||||
|
| should | be oiled | immediately. |
| |||
Ratchet | mechanism | Ratchet mechanism | la. | Clean mechanism with air tool oil |
slips or | will not loosen | is dirty | lb. | Replace worn mechanism |
Notes:
