SERVICE A ADJUSTMENTS
TO START ENGINE WITH A WEAK BATTERY
(See Fig. 29)
CAUTION:
and smoking materials away from bat- ateexptosivegases. Keep sparks, flame teries. Always wear eye protection when around batteries.
If your battery is too weak to start the engine, it should be
rectlarged_ if "jumper cables" are used for emergency starting, follow this procedure:
IMPORTANT: YOUR TRACTOR IS EQUIPPED WiTH A 12
VOLT NEGATIVE GROUNDED SYSTEM. THE OTHER
VEHICLE MUST ALSO BE A 12 VOLT NEGATIVE GROUNDED SYSTEM. DO NOT USE YOUR TRACTOR BATTERY TO START OTHER VEHICLES.
TO ATTACH JUMPER CABLES -
oConnect each end of the RED cable to the POSITIVE
(+)terminal of each battery, taking care not to short against chassis,
•Connect one end of the BLACK cable to the NEGA- TIVE
=Connect the other end of the BLACK cable to good CHASSIS GROUND, away from fuel tankand battery.
TO REMOVE CABLES, REVERSE ORDER -
=BLACK cable first from chassis and then from the fully charged battery
. RED cable last from both batteries,
TO REPLACE HEADLIGHT BULB
=Raise hood
•Pull bulb holder out of the hole in the backside of the griiL
. Replace bulb in holder and push bulb holder securely back into the hole in the backside of the grill
°Close hood.
INTERLOCKS AND RELAYS
Loose or damaged wiring may cause your tractor to run poorty, stop running, or prevent it from starting
=Check wiring, See electrical wiring diagram in the Repair Parts section of this manual
TO REPLACE FUSE
Replace with 30 amp
TO REMOVE HOOD AND GRILL ASSEMBLY
(See Fig. 30)
°Raise hood
o Unsnap headlight wire connector,
°Stand in front of tractor. Grasp hood at sides, tilt toward engine and lift off of tractor,
. To replace, reverse above procedures
"POSITIVE" (+) | "NEGATIVE" |
HOOD
FIG. 30
FIG. 29
26
