TO LEVEL MOWERHOUSING
Adjust the mowerwhile tractor is parked on level ground or driveway. Make sure tires are properly inflated(See "PROD- UCT SPECIFICATIONS"). If tires are over or underinflated,you will not propedy adjust your mower.
SIDE-TO-SIDEADJUSTMENT
•Raise mower to its highestposition.
•At the midpoint of both sides of mower, measure heightfrom bottom edge of
mower to ground. Distance "A" on both sides of mower should be the same or within 1/4" of each other.
•If adjustment is necessary, make adjust- ment on one side of mower only.
•To raise one side of mower, tighten lift link adjustment nut on that side.
•To lower one side of mower, loosen lift link adjustment nut on that side.
NOTE: Each full turn of adjustment nut will change mower height about I18".
Bottom , -
ofcu. - Qfcu.
Suspension
Arm
equal in length. Both links shouldbe approximately
•If linksare not equal in
•To lower front of mower loosen nut=E"
on both front linksan equal number of turns.
•When distance"D" is 1/8" to 1/2" lower at frontthan rear, tighten nuts =F" against trunnionon both front links.
•To raise front of mower, loosen nut"F" from trunnionon both front links.
Tighten nut "E" on both front linksan equal number o.ftums.
•When distance =D" is 1/8"to 1/2" lower
at front than rear,_tighten nut "F" against trunnionon both front links.
•Recheck
. - Mandrel
Both Front Links Should be Equal in Length
Nut =E"
Nut "F"
Lift Link Adj | Nut | Trunnion |
|
|
Recheck measurements after adjusting.
_ide. If the
ront links equally so mower will stay evel
ro obtain the best cutting results, the nower housing should be adjusted so that he front is approximately 1/8" to 1/2" :}wer than the rear when the mower is in :s highest position.
;heck adjustment on fight side of tractor. /leasure distance "D" directly in front and )ehind the mandrel at bottom edge of nower housing as shown.
Before making any necessary adjust- ments, check that both front links are
Front Links Trunnion
TO REPLACE MOWER BLADE DRIVE
BELT (See Illustration Next Page) The mower blade drive belt may be replaced without tools. Park the tractor on level surface. Engage parking brake.
BELT REMOVAL
•Remove mower from tractor (See "TO REMOVE MOWER" in this section of
this manual).
•Work belt off both mandrel pulleys a_l idler pulleys.
•Pull belt away from mower.
22