Your new tractorhasbeen assembled at the factory with exception of those partsleft unassembledfor shippingpurposes.To ensure safe and proper operationef_youfdk_t6i" all partsand hardware you assemble must be tightened securely. Use the correcttools as necessary to insureproper tightness. Review the video cassette before you begin.
TOOLS REQUIRED | FOR | • Remove protective | materials from trac- | |
ASSEMBLY |
| tor hood and grill. |
| |
A socketwrench set will make assembly | IMPORTANT: Check for and remove any | |||
staples in skid that may puncture tires | ||||
easier. Standard wrench sizes you need | ||||
where tractor is to roll off skid. | ||||
are listedbelow. |
| |||
|
| Insert | ||
(1) 9/16" wrench | (1) Utilityknife |
| ||
|
| |||
(2) 1/2" wrench | (1) Pliers | ._ | ||
(1) PhillipsScrewdriver | ||||
|
| |||
(1) Tire pressure gauge | _ | Large Flat Washer | ||
When rightor left hand is mentioned in |
| Sheet | ||
this manual, itmeans, fromyour point of | Steering | Metal | ||
view, when you are in the operatingposi- | Screw | |||
tion (seated behind the steering wheel). | Wheel |
| ||
|
| |||
TO REMOVE TRACTOR FROM | SteeringWheel | Steering | ||
CARTON |
| Bushing | ||
|
| |||
UNPACK CARTON
•Remove all accessible loose parts and parts boxes from shipping carton (See page 6).
•Cut, from top to bottom, along lines on all four comers of shipping carton, and lay panels flat.
•Check for any additional loose parts or boxes and remove.
AdapterTabs
toen0
Steering (Assembly Position)
BEFORE ROLLING TRACTOR OFF SKID
A'n'ACHSTEERING WHEEL
•Slide the steering bushing over the steering shaft.
•Raise steering shaft forward until screw holes in dash line up with steering bush- ing. Install two (2) sheet metal screws and tighten securely.
•Position steering boot over steering shaft.
•Place tabs of steering boot over tab slots in dash and push down to secure.
•Slide steering wheel adapter onto upper steering shaft.
•Position front wheels of the tractor so they are pointing straight forward.
•Position steering wheel so cross bars are horizontal (left to right) and slide onto adapter..
•Assemble large flat washer and
•Snap steering wheel insert into center of steering wheel.
SteeringShaft:/ | , | _ | ,,',,' | |
(Shipping .,,,,'_," |
|
|
| |
Position) | "" | _ ,' F Tab Slot | ||
TO ROLL TRACTOR OFF SKID
Operation section for
•Press lift lever plunger and raise attach- ment lift lever to its highest position.
•Release parking brake by depressing clutch/brake pedal.
•Place gearshift lever in neutral (N) posi- tion.
•Roll tractor forward off skid.
•Remove banding holding discharge guard up against tractor.
8
