TRANSAXLE SHIFTER LINKAGE AND ADJUSTMENT
The transaxle should be in neutral when
the gear shift lever is in the neutral (N) (lock gate) position. The adjustment is preset at the factory; however, if adjust- ment is needed, proceed as follows:
•Make sure transaxle is in neutral (N).
•Loosen two Iocknuts on tie red.
•Tum center rod until gearshift lever falls into neutral lock gate on fender console.
•Tighten Iocknuts securely.
Gearshift Lever
Neutral Lock
•Replace washers and snap retaining ring securely in axle groove.
•Replace axle cover.
NOTE: To seal tire punctures and prevent flat tires due to slow leaks, tire sealant may be purchased from your local parts dealer. Tire sealant also prevents tire dry rot and corrosion.
Washers
Retaining
Ring
__Gate
Locknuts
Transaxle
TO ADJUST STEERING WHEEL ALIGN-
MENT
If steering wheel crossbars are not hori- zontal (left to right) when wheels are posi-
tioned straight forward, remove steering wheel and reassemble per instructions in
the Assembly section of this manual.
FRONTWHEEL
The front wheel
TO REMOVE WHEEL FOR REPAIRS
•Block up axle securely.
•Remove axle cover, retaining ring and washers to allow wheel removal (rear wheel contains a square key - Do not lose).
•Repair tire and reassemble.
•On rear wheels only: align grooves in rear wheel hub and axle. Insert square key.
Axle Cover | '_ |
(Rear Wheel Only)
TO START ENGINE WITH A WEAK BATTERY
_CAUTION:
ies. Always wear eye protection when around batteries.
If your battery is too weak to start the
engine, it should be recharged. (See "BATTERY" in the MAINTANCE section of
this manual).
If "jumper cables" are used for emergency starting, follow this procedure: IMPORTANT: Your tractor Is equipped with a 12 volt negative grounded system. The other vehicle must also be a 12 volt negative grounded system. Do not use your tractor battery to start other vehicles.
TO ATTACH JUMPER CABLES -
•Connect each end of the RED cable to the POSITIVE (+) terminal of each bat-
tery, taking care not to short against chassis.
•Connect one end of the BLACK cable to the NEGATIVE
•Connect the other end of the BLACK cable to good CHASSIS GROUND, away from fuel tank and battery
TO REMOVE CABLES, REVERSE ORDER
•BLACK cable first from chassis and then from the fully charged battery
•RED cable last from both batteries
24