REPLACING BATTERY , _
_CAUTION: Do not short battery' : : terminals by allowing a wrench or any other object to contact both terminals at the same time. Before connecting battery, remove metal bracelets, wristwatch
bands,rings,etc.
Positive terminal must be connected first to prevent sparking from accidental grounding.
•Lift hood to raised position.
•Remove terminal guard:
•Disconnect BLACK battery cable then RED battery cable and carefully remove battery from tractor.
•install new battery with terminals in same position as old battery.
•Reinstall terminal guard.
•First connect RED battery cable to
positive (+) battery terminal with hex bolt and keps nut as shown. Tighten
securely.
•Connect BLACK grounding cable to negative
•Close terminal access doors.
•Close hood.
Positive
Cable
Terminal
GuardCable
TO REPLACE HEADLIGHT BULB
•Raise hood.
•Pull bulb holder out of the hole in the backside of the gdll.
•Replace bulb in holder and push bulb holder securely back into the hole in the backside of the grill.
•Close hood.
INTERLOCKS AND RELAYS
Loose or damaged wiring may cause your tractor to run poorly, stop running, or prevent it from starting.
•Check wiring. See electrical wiring diagram in the Repair Parts section.
TO REPLACE FUSE
Replace with 30 amp
TO REMOVE HOODAND GRILL ASSEMBLY
•Raise hood.
•Unsnap headlight wire connector.
•Stand in front of tractor. Grasp hood at
sides, tilt toward engine and lift off of tractor.
•To replace, reverse above procedures.
Connector
ENGINE
Maintenance, repair, or replacement of the emission control devices and systems, which are being done at the customers expense, may be performed by any non- road engine repair establishment or individual. Warranty repairs must be
performed by an authorized engine manufacturer's service outlet.
TO ADJUST THRO't'rLE CONTROL CABLE
The throttle control has been preset at the factory and adjustment should not be necessary. Check adjustment as de- scribed below before loosening cable. If adjustment is necessary, proceed as
follows:
•With engine not running, move throttle control lever to fast position.
•Check that swivel is against side of quarter circle. If it is not, loosen cable clamp screw and pull cable back until swivel is against quarter circle. Tighten
cable clamp screw securely.
TO ADJUST CHOKE CONTROL
The choke control has been preset at the factory and adjustment should not be necessary. Check adjustment as de- scribed below before loosening cable. If
adjustment is necessary, proceed as follows:
•With engine not running, move choke
26
