3.Disconnect BLACK battery cable then RED battery cable and carefully remove battery from tractor.

4.Install new battery with terminals in same position as old battery.

5.Reinstall terminal guard.

6.First connect RED battery cable to positive (+) battery terminal with hex bolt and keps nut as shown. Tighten securely.

7.Connect BLACK grounding cable to negative (-) battery terminal with remaining hex bolt and kepe nut. Tighten securely

8.Close terminal access doors.

9.Close hood.

Keps Nut\

_

 

Hex Bolt

Termina: :

_

_

"_

Door_

_.__(Red)

[_1__ _Cable

GuardCable

TO REPLACE HEADLIGHT BULB

1.Raise hood.

2.Pull bulb holder out of the hole in the backside of the gdll.

3.Replace bulb in holder and push bulb holder securely back into the hole in the backside of the grill.

4.Close hood.

INTERLOCKS AND RELAYS

Loose or damaged wiring may cause your tractor to run poorly, stop running, or prevent it from starting.

Check wiring. See electrical wiring

diagram in the Repair Parts section.

TO REPLACE FUSE

Replace with 20 amp automotive-type plug-in fuse. The fuse holder is located behir_:lthe dash.

TO REMOVE HOOD AND GRILL ASSEMBLY

1.Raise hood.

2.Unsnap headlight wire connector.

3.Stand in front of tractor. Grasp hood at

sides, tilt toward engine and lift off of tractor.

4.To replace, reverse above procedure.

Hood

I

-

 

\

HeadlightWire

i

 

 

 

I

/

I

Connector

,/ ,:_

ENGINE

Maintenance, repair, or replacement of the emission control devices and sys- tems, which are being done at the customers expense, may be performed by any non-road engine repair establish- ment or individual. Warranty repairs must

be performed by an authorized engine manufacturers service outlet.

TO ADJUST THROTTLE CONTROL CABLE

The thrcttle control has been preset at the factory and adjustment should not be necessary. Check adjustment as de- scribed below before loosening cable. If

adjustment is necessary, proceed as follows:

1.With engine not running, move throttle control lever to fast position.

2.Check that swivel is against side of quarter circle. If it is not, loosen cable clamp screw and pull cable back until swivel is against quarter cimle.

Tighten cable clamp screw securely.

Clamp Screw

Quarter Circle

TO ADJUST CHOKE CONTROL

The choke control has been preset at the factory and adjustment should not be necessary. Check adjustment as de- scribed below before loosening cable. If

adjustment is necessary, proceed as follows:

1.With engine not running, move choke control (located on dash panel) to full choke position.

27

Page 27
Image 27
Craftsman 917.27184 owner manual Engine