Label
Terminal
Battery
Door
INSTALL SEAT
Adjust seat before tightening adjustment knob.
1.Remove adjustment knob and flat washer securing seat to cardboard
packing and set aside for assembly of seat to tractor.
2, Pivot seat upward and remove from the cardboard packing. Remove the
cardboard packing and discard.
3.Place seat on seat pan so head of shoulder bolt is positioned over targe slotted hole in pan.
4.Push down on seat to engage shoulder bolt in slot and pull seat towards rear of tractor.
5.Pivot seat and pan forward and assemble adjustment knob and flat washer loosely. Do not tighten.
6.Lower seat into operating position and sit in seat.
7.Slide seat until a comfortable position is reached which allows you to press clutch/brake pedal all the way down.
8.Get off seat without moving its
adjusted position.
8.Raise seat and tighten adjustment knob securely.
Bolt
NOTE: You may now roll or drive you tractor off the skid. Follow the approl: instruction below to remove the tract, from the skid.
TO ROLLTRACTOR OFF SKID (€ Operation section for location al function of controls)
1.Press lift lever plunger and raise attachment tilt lever to its highest
position.
2.Release parking brake by depre,, clutch/brake pedal.
3.Place gearshift lever in neutral (1_ position,
4.Roll tractor forward off skid.
5.Remove banding holding deflect shield up against tractor.
TO DRIVETRACTOR OFF SKID (',
Operation section for location al function of controls)
_WARNING: Before starting, read. understand and follow all instruction',
the Operation section of this manual. sure tractor is in a
Be sure the area in front of tractor is of other people and objects,
1.Be sure all the above assembly s have been completed.
2, Check engine oil level and fill fu_ tank with gasoline.
3.Sit on seat in operating position, depress clutch/brake pedal and s, the parking brake.
4.Place gear shift lever in neutral (i_ position.
5.Press lift lever plunger and raise attachment lift lever to its highest
position.
6.Start the engine. After engine ha_ started, move throttle control to id
position.
7.Depress clutch/brake pedal into f "BRAKE" position and hold. Mow gearshift lever to 1st gear,
8.Slowly release clutch/brake ped_ s_owly drive tractor off skid.
9.Apply brake to stop tractor, set pa brake and place gearshift lever in neutral position.
10.Turn ignition key to "OFF" positior Continue with the instructions that fo
9
