•The average lawn should be cut to approximately
•For best cutting performance, grass over 6 inches in height should be mowed twice, Make the first cut
_I_CAUTION: Do not operate the mower without either the entire grass catcher, on mowers so equipped, or the deflector shield in place.
Attachment
ClutchLeverAttachemnt
=Engaged"High
Position, Position
relatively high; the second to desired height,
TO ADJUST GAUGE WHEELS
Gauge wheels are propedy adjusted when they are slightly off the ground when mower is at the desired cutting height in operating position. Gauge wheels then keep the deck in proper position to help prevent scalping in most terrain conditions.
NOTE: Adjust gauge wheels with tractor on a flat level surface.
1.Adjust mower to desired cutting height (See _TO ADJUST MOWER CUTTING
HEIGHT" in the Operation section of this manual).
2.With mower in desired height of cut
position, gauge wheels should be assembled so they are slightly off the ground. Install gauge wheel in appropriate hole with shoulder bolt, 3/ 8 washer, and
3.Repeat for opposite side installing
gauge wheel in same adjustment hole.
Gauge
Wheel
Shoulder
3/8_/_Bolt
Gauge Wheel
TO OPERATE MOWER
Your tractor is equipped with an operator presence sensing switch. Any attempt by the operator to leave the seat with the engine running and the attachment clutch engaged will shut off the engine.
1.Select desired height of cut.
2.Start mower blades by engaging attachment clutch control.
TO STOP MOWER BLADES - disengage attachment clutch control.
Low
Position
Position
Deflector
Shield
TO OPERATE ON HILLS
_CAUTION: Do not drive up or down hills with slopes greater than 15" and do not drive across any slope,
•Choose the slowest speed before starting up or down hills.
•Avoid stopping or changing speed on hills,
•If slowing is necessary, move throttle control lever to slower position.
•If stopping is absolutely necessary, push clutch/brake pedal quickly to brake position and engage parking brake.
•Move gearshift lever to 1st gear. Be sure you have allowed room for tractor to roll slightly as you restart movement.
•To restart movement, slowly release parking brake and clutch/brake pedal.
•Make all tums slowly.
TO TRANSPORT
•Raise attachment lift to highest position with attachment lift control.
•When pushing or towing your tractor, be sure gearshift lever is in neutral (N) position.
•Do not push or tow tractor at more than five (5) MPH.
NOTE: To protect hoodfrom damage when transporting your tractor on a truck or a trailer, be sure hood is closed and secured to tractor. Use an appropriate means of tying hood to tractor (rope, cord, etc.).
t4
