Door
INSTALL SEAT
Adjust seat before tightening adjustment knob,
1.Remove adjustment knob end fiat washer secudng seat to cardboard packing and set aside for assembly of seat to tractor.
2.Pivot seat upward and remove from the cardboard packing, Remove the cardboard packing and discard,
3.Place seat on seat pan so head of shoulder bolt is positioned over large slotted hole in pan.
4.Push down on seat to engage shoulder bolt in slot and pull seat towards roar of tractor.
5.Pivot seat and pan forward end assemble adjustment knob and fiat washer loosely. Do not tighten.
6.Lower seat into operating position and sit in seat,
7.Slide seat until a comfortable position is reached which allows you to press clutch/brake pedal ell the way down.
8.Get off seat without moving its adjusted position.
9.Raise seat and tighten adjustment knob securely,
Seat
Bolt
Flat Washer
NOTE: You may now rollor drive your tractor off the skid. Follow the appropriate instructionbelow to remove the tractor from the skid.
TO ROLLTRACTOR OFF SKID (See Operation section for location and function of controls)
1.Press lift lever plunger and raise attachment lift lever to its highest position.
2.Release parking brake by depressing clutch/brake pedal.
3.Place gearshift lever in neutral {N) position,
4.Roll tractor forward off skid.
5.Remove banding holding deflector shield up against tractor.
TO DRIVETRACTOR OFF SKID (See Operation section for location and function of controls)
,_WARNING: Before starting, read, understand and follow all instructionsin
the Operation section of this manual. Be sure tractor is in a
of other people and objects.
1.Be sure all the above assembly steps have been completed,
2.Check engine oil level and fill fuel tank with gasoline.
3.Sit on seat in operating position, depress elutch/brake pedal and set the parking brake.
4.Place gear shift lever in neulfal (N)
position.
5, Press lift lever plunger and raise attachment lift lever to its highest position.
6.Start the engine. After engine has started, move throttle control to idle position.
7.Depress clutch/broke pedal into full "BRAKE" position and hold. Move gearshift lever to 1st gear.
8.Slowly release clutch/brake pedal and slowly drive tractor off skid.
9.Apply brake to stop tractor, set parking brake and place gearshift lever in
neutral position.
10.Turn ignition key to "OFF" position.
Continue with the instructions that follow.
9
