Weber 5000 Series owner manual Install the lid

Step 29

Install the lid

You will need: lid, two hinge pins and two hair pin cotters.

Set the lid in place. Align the hinges at the rear of the barbecue. Insert hinge pins from the outside. Insert hair pin cotters into the small holes in the hinge pins. Figure 44.

Hair pin cotter

Hinge pin

Figure 44

Step 30

Install tool holders, control panel, burner control knobs and FlameCheck button

You will need: three tool holders, control panel, three burner control knobs and FlameCheck button.

Hook the tool holders over the frame rail. Figure 45.

Set the control panel in place over both frame braces. (Hold the Crossover Ignition button up while setting the control panel in place.) Place your thumbs over the control panel push-in buttons and push them into the frame brace until they snap into place. Figure 45 (a).

Push on the burner control knobs and FlameCheck button. Figure 45 (b).

Hole in frame brace

(a)

Control panel push-in buttons

(b)

Tool holders

Figure 45

27