Bad spark plug, Dirty fuel filter | Craftsman 917.272233 manual

TROUBLESHOOTING		CHART
PROBLEM	CAUSE		CORRECTION
WIll not start	1.	Out of fuel.	1.	Fill fuel tank.
	2.	Engine not "CHOKED"	2.	See "TO START ENGINE"
		properly.		in Operation section.
	3.	Engine flooded.	3.	Wait several minutes
				before attempting to start.

4.Bad spark plug.

5.Dirty air filter.

6.Dirty fuel filter.

7Water in fuel.

8.Loose or damaged wiring.

9.Carburetor out of adjustment.

10.Engine valves out of adjustment.

Hard to start	1.	Dirty air filter.
	2.	Bad spark plug.
	3.	Weak or dead battery.
	4.	Dirty fuel filter.
	5.	Stale or dirty fuel.

4.Replace spark plug.

5.Clean/replace air filter.

6.Replace fuel filter.

7.Drain fuel tank and carburetor, refill tank with fresh gasoline and replace fuel filter.

8.Check all widng.

9.See "To Adjust Carburetor"

in Service Adjustments section.

10.Contact a Sears or other qualified service center.

1.Clean/replace air filter.

2.Replace spark plug.

3.Recharge or replace battery.

4.Replace fuel filter.

5.Drain fuel tank and refill with fresh gasoline.

Enginewlll not turn over

6.Loose or damaged wiring. 6. Check all widng.

7.Carburetor out of adjustment. 7. See "To Adjust Carburetor" in Service Adjustments section.

8.	Engine valves out of	8.	Contact	a Sears or other
	adjustment.		qualified	service center..
1.	Clutch/brake pedal not	1.	Depress	clutch/brake
	depressed.		pedal.
2.	Attachment clutch is	2.	Disengage attachment
	engaged.		clutch.
3.	Weak or dead battery.	; 3.	Recharge or replace
4.	Blown fuse.		battery.
4.	Blown fuse.	4.	Replace fuse.
5.	Corroded battery terminals.	5.	Clean battery terminals.
6.	Loose or damaged wiring.	6.	Check all widng.
7.	Faulty ignition switch,	7.	Checldmplace ignition
			switch.

	8.	Faulty solenoid or starter.		8.	Check/replace solenoid or
					starter.
	9,	Faulty operator	presence	9.	Contact a Sears or other
		swithch(es).			qualified service center.
Engine clicks but	t,	Weak or dead	battery.	1.	Recharge or replace battery
NIII not start	2.	Corroded battery terminals.		2.	Clean battery terminals.
	3.	Loose or damaged widng.		3.	Check all widng.
	4.	Faulty solenoid or starter.		4.	Check/replace solenoid or
					starter.

30

Image 30

Craftsman 917.272233 owner manual Troubleshooting Chart Problem Cause Correction, Bad spark plug, Dirty fuel filter

Contents

Icrrftsmrn Limitedtwoyear Warranty on Craftsman Riding Equipment Parts General Operation Slope OperationDo not IV. Service When necessary Mower blades are sharp and can cutIlL Children Defects or other reproductive harm. Wash hands after handUng Reverse Battery AMP/HRSasoline 3,5 Gallons Capacity Unleaded Andtype Regular Charging 2Flanged Mower Retainer SpringsHer Knob Install Seat Tools Required for AssemblyHowto SET Upyourtractor To Removetractor from Carton Placeseatonseatpansoheadof Assemble Gaugewheelsto Mower Deck Plate assembly and mower brackets Install hex bolts and look nuts asInstall Mower and Drive Belt TabHole Nose Roller Lock Nut B Bracket Belts Check Tire PressureCheck Mower Levelness Check Brake System RlR Knowyourtractor Stopping Mower Blades To Adjust Mower Cutting HeightHowto Useyourtractor To SET Parking Brake Ground Drive To Operate Mower To Adjust Gauge WheelsTo Operate on Hills Totransport ADD Gasoline Towing Carts and Other AI-FACH- MentsBefore Startingthe Engine Check Engine OIL Level To Start Engine Cold Weather Starting 50 F and below MOWlNGTIPS General Recommendations Before Each USE Tires TractorBrake Operation Operator Presence System Engine Lubrication To Clean BAI-FERYAND TerminalsTransaxle Cooling To Change Engine OIL Cleaning Clean AIR INTAKE/COOLING AreasTo Service Cartridge Engine OIL Filter SIDE-TO-SIDE Adjustment To Install MowerTo Level Mower Housing Tractor To Replace Mower Drive Belt Both Frontlinks Must be Equal LengthImportant Deck must be level side-to Idlers to see that they rotate freely To Replace Mower Blade Drive Belt Mower Drive Belt InstallationTo Adjust Brake With Parking Brake Engaged Front Wheel TOE-IN/CAMBER Transaxle Gear Shift Lever Neutral AdjustmentTo Adjust Steering Wheel ALIGN- Ment Front wheel toe-in and camber are Interlocks and Relays To Replace Headlight LampTo Attach Jumper Cables To Replace Fuse To Adjust Choke Control To Remove Hood and Grill AssemblyTo Adjust Throttle Control Cable Tighten clamp screw securely Final SEI-IING To Adjust CarburetorRecheck idle speed. Readjust if necessary Acceleration Test Engine OIL BatteryEngine Fuel System Cylinders Bad spark plug Troubleshooting Chart Problem Cause CorrectionReplace spark plug Clean/replace air filter Dirty fuel filter Troubleshooting Chart Problemcause Roubleshooting Chart Problem Cause Schematic Tractor - Model NumberTernator Tractor --MODEL Number KEY Part Description Tractor - Model Number 917.272233 Chassis and Enclosures KEY Part Description Tractor -- Model Number Ground Drive Tractor - Model Number Ground Drive EVX Tractor --MODEL Number 917.272233 Steeringassembly Tractor --MODEL Number 917.272233 Steering Assembly Engine Tractor -- Model Number + !i Tractor -- Model Number Seat Assembly KEY Part NO. NO. Description Decals Wheels &TIRES Tractor - Model Number Mowerdeck Tractor -- Model Number Mowerdeck 160 Part Descr 111 HEAD/VALVE/DREATHER KEY Part NO. NO.DESCRIPTION Crankcase KEY Part NO, NO.DESCRIPTION Ignitionielectrica AIR INTAKE/FILTRATION Blower Housing & Baffles KEY Part NO. NO.DESCRIPTIONIGNITION/CHARGING KEY Part NO. NO.DESCRIPTION Not Illustrated Starting System Engine Controls Keypart NO. no Description Engine Controls KEY Part NO. no DescriptionKeypart NO. no Fuel Svstmel KEY Part NO. no Description Page Suggested Guide for Sighting Slopes for Safe Operation Only Ride UP and Down Hill Not Across Hill Anydaye,cxrkjhtU.S.Aody 179435 5.2.01 TR