Craftsman 917.27267 owner manual AIR Filter, Belts, To Change Engine OIL

Models: 917.27267

1 56
Download 56 pages 49.52 Kb
Page 19
Image 19

NOTE:The originalequipmentbattery on your tractor is maintenancefree. Do not attemptto open or removecaps or covers. Adding or checking levelof electrolyteis not necessary.

TO CLEAN BATTERYANDTERMINALS

Corrosionanddirt on the batteryandtermi- nalscan causethe batteryto "leak"power.

1.DisconnectBLACKbattery cablefirst then RED battery cableand remove batteryfrom tractor.

2.Rinsethe batterywith plain water and dry.

3.Cleanterminalsand battery cableends with wire brush until bright.

4.Coat terminalswith greaseor petro- leumjelly.

5.Reinstallbattery (See "REPLACING BATTERY"in the SERVICEAND AD- JUSTMENTSsectionof this manual).

TRANSAXLE COOLING

Keeptransaxlefree from build-upof dirt and chaff whichcan restrictcooling.

V-BELTS

Check V-belts for deterioration and wear after 100 hours of operation and replace if necessary. The belts are not adjustable.

Replace belts if they begin to slip from wear.

ENGINE

LUBRICATION

Only use high quality detergent oil rated with API service classification SF-SJ.

Select the oil'sSAE viscosity grade

according to your expected operating temperature.

SAE VISCOSITY GRADES

NOTE: Although multi-viscosity oils (5W30, 10W30 etc.) improve starting in cold weather, these multi-viscosity oils will result in increased oil consumption when used above 32°E Check your engine oil

level more frequently to avoid possible engine damage from running low on oil.

Change the oil after every 25 hours of op- eration or at least once a year if the tractor is not used for 25 hours in one year.

Check the crankcase oil level before start- ing the engine and after each eight (8) hours of operation. Tighten oil fill cap/

dipstick securely each time you check the oil level.

TO CHANGE ENGINE OIL

Determine temperature range expected

before oil change. All oil must meet API service classification SF-SJ.

Be sure tractor is on level surface.

Oil will drain more freely when warm.

Catch oil in a suitable container.

1.Remove oil fill cap/dipstick. Be careful not to allow dirt to enter the engine when changing oil.

2.Remove yellow cap from end of drain valve and install the drain tube onto the

fitting.

Oil Drain Valve

cose0

Locked I '_ -_ _ __

e, ow- ===- -

Drain Tube __

3.Unlock drain valve by pushing inward slightly and turning counterclockwise.

4.To open, pull out on the drain valve.

5.After oil has drained completely, close and lock the drain valve by pushing inward and turning clockwise until the pin is in the locked position as shown.

6.Remove the drain tube and replace the cap onto the end of the drain valve.

7.Refill engine with oil through oil fill dip- stick tube. Pour slowly. Do not overfill.

For approximate capacity see "PROD- UCT SPECIFICATIONS" section of this manual.

8.Use gauge on oil fill cap/dipstick for checking level. For accurate reading, tighten dipstick cap securely onto the tube before removing dipstick. Keep oil at "FULl.:'line on dipstick. Tighten cap onto the tube securely when finished.

AIR FILTER

Your engine will not run properly using a dirty air filter. Replace pre-cleaner after

every 25 hours of operation or every season. Service paper cartridge every

100 hours of operation or every season, whichever occurs first.

Service air cleaner more often under dusty conditions.

19

Page 19
Image 19
Craftsman 917.27267 owner manual AIR Filter, Belts, To Change Engine OIL