![](/images/new-backgrounds/1094660/9466039x1.webp)
•Keep battery bolts tight.
•Keep small vent holes open.
•Recharge at
TO CLEAN BATTERY AND TERMINALS
Corrosion and dirt on the battery and terminals can cause the battery to "leak" power.
1.Disconnect BLACK battery cable first then RED battery cable and remove battery from tractor.
2.Rinse the battery with plain water and dry.
3.Clean terminals and battery cable ends with wire brush until bright.
4.Coat terminals with grease or petro- leum jelly.
5.Reinstall battery (See "REPLACING BATTERY" in the Service and Adjust- ments section of this manual).
TRANSAXLE COOLING
The transmission fan and cooling fins should be kept clean to assure proper cooling.
Do not attempt to clean fan or transmis- sion while engine is running or while the transmission is hot. To prevent possible
damage to seals, do not use high pressure water or steam to clean transaxle.
•Inspect cooling fan to be sure fan blades are intact and clean.
•Inspect cooling fins for dirt, grass clip- pings and other materials. To prevent damage to seals, do not use com-
pressed air or high pressure sprayer to clean cooling fins.
TRANSAXLE PUMP FLUID
The transaxle was sealed at the factory
and fluid maintenance is not required for the life of the transaxle. Should the trans-
axle ever leak or require servicing, contact a Sears or other qualified service center.
V-BELTS
Check
ENGINE
LUBRICATION
Only use high quality detergent oil rated with API service classification
Select the oil'sSAE viscosity grade according to your expected operating temperature.
NOTE: Although
is not used for 50 hours in one year. Check the crankcase oil level before start-
ing the engine and after each eight (8) hours of operation. Tighten oil fill cap/ dipstick securely each time you check the oil level.
TO CHANGE ENGINE OIL
Determine temperature range expected
before oil change. All oil must meet API service classification
•Be sure tractor is on level surface.
•Oil will drain more freely when warm.
•Catch oil in a suitable container.
1.Remove oil fill cap/dipstick. Be careful not to allow dirt to enter the engine when changing oil.
2.Remove yellow cap from end of drain valve and install the drain tube onto the
fitting.
Oil Drain Valve
Closed and
Locked
Yellow
Cap
Drain Tube
02463
20