![](/images/new-backgrounds/1094660/9466055x1.webp)
ENGINE
Maintenance, repair, or replacement of the emission control devices and systems, which are being done at the customers expense, may be performed by any
TO ADJUSTTHROTTLE CONTROL CABLE
The throttle control has been preset at the factory and adjustment should not be nec- essary. Check adjustment as described below before loosening cable. If adjust- ment is necessary, proceed as follows:
1.With engine not running, move throttle control lever from slow to choke posi- tion. Slowly move lever from choke to fast position.
2.Check that holes "A" in governor control lever and hole in governor plate
Governor Control Lever Governor Control Plate
'\
\
\
\
"A" | Clamp Screw | Cable |
TO ADJUST CARBURETOR
NOTE: The carburetor on this engine is low emission. It is equipped with an idle fuel adjusting needle with a limiter cap, which allows some adjustment within the limits allowed by the cap. Do not attempt to remove the limiter cap. The limiter cap cannot be removed without breaking the adjusting needle.
The carburetor has been preset at the factory and adjustment should not be necessary. However, minor adjustment may be required to compensate for differ- ences in fuel, temperature, altitude or load. If the carburetor does need adjustment, proceed as follows:
In general, turning idle mixture valve in (clockwise) decreases the supply of fuel to the engine giving a leaner fuel/air mix- ture. Turning the idle mixture valve out (counterclockwise) increases the supply
of fuel to the engine giving a richer fuel/air mixture.
IMPORTANT: Damage to the needle
valve and the seat in carburetor may result
if screw is turned in too tight.
PRELIMINARY SETTING -
1.Air cleaner assembly must be assem- bled to the carburetor when making carburetor adjustments.
2.Be sure the throttle control cable is adjusted properly (see above).
FINAL SETTING
section of the manual.)
1.Start engine and allow to warm for five minutes. Make final adjustments with engine running and shift/motion control lever in neutral (N) position.
2.Move throttle control lever to slow posi- tion. With finger, rotate and hold throttle lever against idle speed screw. Turn idle speed screw to attain 1750 RPM.
3.While still holding throttle lever against idle speed screw, turn idle mixture valve full travel clockwise then coun- terclockwise until engine runs rough.
Turn valve to a point midway between those two positions. Release throttle lever.
ACCELERATION TEST -
4. Move throttle control lever from slow to fast position. If engine hesitates or dies, turn idle mixture valve out (coun- terclockwise) 1/8 turn. Repeat test and continue to adjust, if necessary, until engine accelerates smoothly.
High speed stop is factory adjusted. Do not adjust or damage may result. IMPORTANT: Never tamper with the engine governor, which is factory set for proper engine speed. Overspeed- ing the engine above the factory high speed setting can be dangerous. If you think the
Idle Speed
Lever
Idle Mixture
Valve with
Limiter
28