Keps Nut | Hex Bolt |
| Positive |
Terminal | (Red) Cable |
| |
Guard | Negative |
'': | (Black) Cable |
TO REPLACE HEADLIGHT BULB
1.Raise hood.
2.Pull bulb holder out of the hole in the backside of the grill.
3.Replace bulb in holder and push bulb holder securely back into the hole in the backside of the grill.
4.Close hood.
INTERLOCKS AND RELAYS
Loose or damaged wiring may cause
your tractor to run poorly, stop running, or prevent it from starting.
•Check wiring. See electrical wiring
diagram in the Repair Parts section.
TO REPLACE FUSE
Replace with 20 amp
TO REMOVE HOOD AND GRILL AS- SEMBLY
1.Raise hood.
2.Unsnap headlight wire connector.
3.Stand in front of tractor. Grasp hood at
sides, tilt toward engine and lift off of tractor.
4.When replacing hood, be sure to reconnect the headlight wire connector.
Headlight Wire
Connector
ENGINE
Maintenance, repair, or replacement of the emission control devices and systems, which are being done at the customers ex- pense, may be performed by any
engine repair establishment or individual. Warranty repairs must be performed by an
authorized engine manufacturer's service outlet.
TO ADJUST THROTTLE CONTROL CABLE
The throttle control has been preset at the factory and adjustment should not be nec- essary. Check adjustment as described below before loosening cable. If adjust- ment is necessary, proceed as follows:
1.With engine not running, move throttle control lever from slow to choke posi- tion. Slowly move lever from choke to fast position.
2.Check that holes"A" in governor
control lever and hole in governor plate
GovernorGovernor
Control Lever /Control Plate
Holes "A" "\ % Clam/p"_ _J3@_ Throttle
_o-_ew - Cable
27