Your new tractor has been assembled at the factory with the exception of those parts left unassembled for shipping purposes. To ensure safe and proper operation of your tractor all parts and hardware you assemble must be tightened securely. Use the correct tools as necessary to insure proper tightness. Review the video cassette before you begin.
TOOLS REQUIRED FOR ASSEMBLY
A socket wrench set will make assembly
easier. Standard wrench sizes you need are listed below.
(1) | 3/4"wrench | (1) | Pliers |
(2) | 7/16" wrench | (1) | Utility knife |
(1) Tire pressure gauge
When right or left hand is mentioned in this manual, it means, from your point of view, when you are in the operating posi- tion (seated behind the steering wheel).
TO REMOVE TRACTOR FROM
CARTON
UNPACK CARTON
1.Remove all accessible loose parts and parts boxes from carton.
2.Cut along dotted lines on all four pan- els of carton. Remove end panels and lay side panels flat.
3.Check for any additional loose parts or cartons and remove.
| _ | Insert |
|
| _"_ | 1/2 Hex Nut |
|
Stee" g | _ | Large | Flat |
__ | Washer | ||
Wheel |
|
|
|
| I._ | Steering | Boot |
|
| Tabs |
|
Adapter
Extension Shaft
BEFORE REMOVING TRACTOR FROM SKID
ATTACH STEERING WHEEL
ASSEMBLE EXTENSION SHAFT AND BOOT
1.Slide extension shaft onto lower steer-
ing shaft. Align mounting holes in ex- tension and lower shafts and install 1/4
hex bolt and Iocknut. Tighten securely. IMPORTANT: Tighten bolt and nut se- curely to
2.Place tabs of steering boot over tab slots in dash and push down to secure.
INSTALL STEERING WHEEL
3.Position front wheels of the tractor so they are pointing straight forward.
4.Remove steering wheel adapter from steering wheel and slide adapter onto steering shaft extension.
5.Position steering wheel so cross bars are horizontal (left to right) and slide inside boot and onto adapter.
6.Assemble large flat washer, 1/2 hex nut and tighten securely.
7.Snap steering wheel insert into center of steering wheel.
8.Remove protective materials from trac- tor hood and grill.
IMPORTANT: Check for and remove any
staples in skid that may puncture tires where tractor is to roll off skid.
HOWTO SET UP YOUR TRACTOR
CHECK BATTERY
1.Lift seat pan to raised position. NOTE: If this battery is put into service after month and year indicated on label (label located between terminals) charge
battery for minimum of one hour at
section of this manual for charging instruc- tions).
8
