5. | Move motion control | lever to neutral | |
| (N) position. Shutoff engine and set | ||
| parking | brake. |
|
6. | Engage | transmission | by placing free- |
)1
wheel control in engaged position (See | |
"TO TRANSPORT" | in this section of |
manual). |
|
7. Sitting in the tractor seat, start engine. | |
After the engine is running, move | |
(
j
throttle control to half (1/2) speed. |
| ||
With motion control lever in neutral (N) | |||
position, | slowly disengage | clutch/brake | |
pedal. |
|
|
|
8. Slowly move motion control lever for- | |||
ward, after the tractor moves approxi- | |||
mately five (5) feet, slowly move motion | |||
control lever to reverse position. After | |||
the tractor moves approximately | five | ||
(5) feet return the motion control lever | |||
to the neutral (N) position. Repeat this | |||
procedure with the motion control lever | |||
three (3) | times. |
|
|
Your transmission is now purged and now ready for normal operation.
MOWING TIPS
•Mower should be properly leveled for
best mowing performance. See "TO LEVEL MOWER HOUSING" in the
Service and Adjustments section of this manual.
•The left hand side of mower should be used for trimming.
•Drive so that clippings are discharged onto the area that has already been cut.
Have the cut area to the right of the trac- tor. This will result in a more even distri-
bution of clippings and more uniform cutting.
•When mowing large areas, start by turning to the right so that clippings will discharge away from shrubs, fences, driveways, etc. After one or two rounds, mow in the opposite direction making left hand turns until finished.
,cJ
00272
•If grass is extremely tall, it should be mowed twice to reduce load and pos- sible fire hazard from dried clippings.
Make first cut relatively high; the second to the desired height.
•Do not mow grass when it is wet. Wet grass will plug mower and leave undesir- able clumps. Allow grass to dry before mowing.
•Always operate engine at full throttle when mowing to assure better mow- ing performance and proper discharge of material. Regulate ground speed by selecting a low enough gear to give the mower cutting performance as well as the quality of cut desired.
•When operating attachments, select a ground speed that will suit the terrain and give best performance of the at- tachment being used.
17
