Craftsman 917.275632 manual 5/8BoltorPin___lade

The blade can be sharpenedwith a file or on a grindingwheel. Do not attempt to sharpen while on the mower.

Tocheck blade balance,you will need a 5/8" diametersteel bolt, pin, or a cone balancer. (When usinga conebalancer, followthe instructionssuppliedwith balancer.)

NOTE: Do notuse a nail for balancing blade. The lobesof the center hole may appear to be centered,butare not.

•Slide bladeon to an unthreadedportion of the steel bolt or pin and hold the bolt or pin parallelwith the ground. If blade is balanced,it should remainin a horizontalposition. If either end of the blade movesdownward,sharpenthe heavy end untilthe blade is balanced.

5/8"BoltorPin_'__lade

/J_7

Center Hole

BATTERY

Your tractor has a battery charging system which is sufficient for normal use. How-

ever, periodic charging of the battery with an automotive charger will extend its life.

•Keep battery and terminals clean.

•Keep battery bolts tight.

•Keep small vent holes open.

•Recharge at 6-10 amperes for 1 hour. NOTE: The original equipment battery on your tractor is maintenance free. Do not attempt to open or remove caps or covers. Adding or checking level of electrolyte is not necessary.

TO CLEAN BATTERY AND TERMINALS

Corrosion and dirt on the battery and terminals can cause the battery to "leak" power.

1.Remove terminal guard.

2.Disconnect BLACK battery cable first then RED battery cable and remove battery from tractor.

3.Rinse the battery with plain water and dry.

4.Clean terminals and battery cable ends with wire brush until bright.

5.Coat terminals with grease or petro- leum jelly.

6.Reinstall battery (See "REPLACING BATTERY" in the SERVICE AND AD-

JUSTMENTS section of this manual).

TRANSAXLE COOLING

Keep transaxle free from build-up of dirt and chaff which can restrict cooling.

V-BELTS

Check V-belts for deterioration and wear after 100 hours of operation and replace if neces- sary. The belts are not adjustable. Replace belts if they begin to slip from wear.

ENGINE

LUBRICATION

Only use high quality detergent oil rated with API service classification SG-SL

Select the oil's SAE viscosity grade according to your expected operating temperature.

SAE VISCOSITY GRADESt

40 I

oN vl_c _atl e

NOTE: Although multi-viscosity oils

(5W30, 10W30 etc.)improve starting in cold weather, they will result in increased oil consumption when used above 32°R Check your engine oil level more frequent- ly to avoid possible engine damage from running low on oil.

Change the oil after every 50 hours of op- eration or at least once a year if the tractor is not used for 50 hours in one year.

Check the crankcase oil level before start- ing the engine and after each eight (8) hours of operation. Tighten oil fill cap/ dipstick securely each time you check the oil level.

TO CHANGE ENGINE OIL

Determine temperature range expected

before oil change. All oil must meet API service classification SG-SL

•Be sure tractor is on level surface.

•Oil will drain more freely when warm.

•Catch oil in a suitable container.

1.Remove oil fill cap/dipstick. Be careful not to allow dirt to enter the engine

when changing oil.

2.Remove yellow cap from end of drain valve and install the drain tube onto the

fitting.

Oil Drain Valve

Drain

Tube

17