4.Install new batterywith terminalsin same positionas old battery.
5.Reinstallterminalguard.
6.First connectRED batterycableto positive(+) batteryterminalwith hex bolt and kepsnut as shown.Tighten securely.
7.ConnectBLACKgroundingcableto
8.Closeterminalaccess doors.
9.Closehood.
KepsNut___
TerminalyexBolt
Access_ _>_"
Door .
Termi4naF'°"74.... | _,,_,i,_ | ,_,- |
Guard _ | "Negative(Black) | |
............ | Cable |
|
TO REPLACE HEADLIGHT BULB
1.Raise hood.
2.Pull bulb holder out of the hole in the backside of the grill.
3.Replace bulb in holder and push bulb holder securely back into the hole in
the backside of the grill.
4.Close hood.
INTERLOCKS AND RELAYS
Loose or damaged wiring may cause
your tractor to run poorly, stop running, or prevent it from starting.
• Check wiring. See electrical wiring diagram in the Repair Parts section.
TO REPLACE FUSE
Replace with 30 amp
TO REMOVE HOOD AND GRILL AS- SEMBLY
1.Raise hood.
2.Unsnap headlight wire connector.
3.Stand in front of tractor. Grasp hood at sides, tilt toward engine and lift off of tractor.
4.When replacing hood, be sure to re- connect the headlight wire connector.
Hood
Headlight Wire
Connector
ENGINE
Maintenance, repair, or replacement of the emission control devices and systems, which are being done at the customers ex- pense, may be performed by any
engine repair establishment or individual. Warranty repairs must be performed by an
authorized engine manufacturer's service outlet.
TO ADJUST THROTTLE CONTROL CABLE
The throttle control has been preset at the factory and adjustment should not be nec- essary. Check adjustment as described below before loosening cable. If adjust- ment is necessary, proceed as follows:
1.With engine not running, move throttle control lever to fast position.
2.Check that swivel is against stop. If it is not, loosen cable clamp screw and pull cable back until swivel is against stop.
Tighten cable clamp screw securely.
TO ADJUST CHOKE CONTROL
The choke control has been preset at the factory and adjustment should not be nec- essary. Check adjustment as described below before loosening cable. If adjust- ment is necessary, proceed as follows:
1.With engine not running, move choke control (located on dash panel) to full choke position.
2.Loosen knob and remove cover as- sembly from air cleaner.
3.Choke should be closed. If it is not, loosen casing clamp screw and move choke cable until choke is completely closed. Tighten casing clamp screw securely.
4.Replace air cleaner cover assembly and tighten knob.
27
