TO REMOVECABLES,REVERSE ORDER-
1. BLACKcablefirst fromchassisand
then fromthefully chargedbattery, 2, REDcablelastfrom bothbatteries°
WeakorDead FullyCharged
Battery Battery
REPLACINGBATTERY
_WARNING: Do notshortbatterytermi-
nalsbyallowingawrenchoranyotherobject to contactbothterminalsat the sametime,
Before connectingbattery, remove metal
bracelets,wristwatchbands,rings,etc. Positiveterminalmustbeconnectedfirst to
preventsparkingfrom accidentalground- ing.
1. Liftseatpanto raisedposition,,
2, DisconnectBLACK battery cable first then RED battery cable and carefully removebatteryfromtractor.
3.Installnewbatterywithterminalsinsame positionas old battery°
4.FirstconnectREDbatterycableto posi- tive (+)terminalwith hex bolt and keps
nut as shown. Tighten securely.Slide terminalcoveroverterminal
3Replacebulb in holder and push bulb holdersecurelybackintotheholeinthe
backsideof the grill. 4, Closehood.
INTERLOCKSAND RELAYS
Looseor damagedwiring maycauseyour tractorto runpoorly,stoprunning,orprevent it from starting.
, Checkwiring° See electricalwiring dia-
gramin the RepairPartssection°
TO REPLACEFUSE
Replacewith 20ampautomotive4ypeplug- in fuse_ Thefuse holderis located behind
the dash.
TO REMOVE HOOD AND GRILL AS-
SEMBLY
1o Raise hoo&
2.Unsnap headlight wire connector.
3_ Stand in front of tractor. Grasp hood at
sides, tilt toward engine and lift off of tractor.
4_ When replacing hood, be sure to recon- nect the headlight wire connector.
(/ .... _"\ | Hood |
\_ | x |
Headlight Wire
Connector
5, Connect BLACK grounding cable to
Seat
Label
Terminal
(Red)
CableNegative (Black) Cable
TO REPLACE HEADLIGHT BULB 1, Raise hood.
2.Pull bulb holder out of the hole in the
backside of the grill. | 25 |
ENGINE
Maintenance, repair, or replacement of the emission control devices and systems, which are being done atthe customers expense, may be performed by any
must be performed by an authorized engine manufacturer's service outlet,
TO ADJUST THROTTLE CONTROL CABLE
The throttle control has been preset at the factory and adjustment should not be neces- sary. Check adjustment as described below before loosening cable, If adjustment is necessary, proceed as follows:
1.With engine not running, move throttle control lever from slow to choke position, Slowly move lever from choke to fast position,
