Keys |
|
| Slope Sheet | |
(1) | Oil Drain | Tube | ||
| ||||
| For | Future | Use |
(2) Keys
Your new tractor has been assembled at the factory with the exception of those parts left
unassembled for shipping purposes. To ensure safe and proper operation of your tractor all parts and hardware you assemble must be tightened securely. Use the correct tools as necessary to insure proper tightness.
TOOLS REQUIRED FOR ASSEMBLY
A socket wrench set will make assembly
easier. | Standard | wrench | sizes | you need | |
are | listed | below. |
|
|
|
(1) | 3/4" | wrench | (1) | Pliers |
|
(1) | 1/2" | wrench | (1) | Utility | knife |
(1) | Tire | pressure | gauge |
|
|
When right or left hand is mentioned in this manual, itmeans when you are in the operating position (seated behind the steering wheel).
CHECK BATTERY
1.Lift seat pan to raised position.
NOTE: If this battery is put into service after month and year indicated on label (label located between terminals) charge battery for minimum of one hour at
"BATTERY" in Maintenance section of this manual for charging instructions).
Seat
Label
TO REMOVE TRACTOR FROM CARTON
UNPACK CARTON
1.Remove all accessible loose parts and parts boxes from carton.
2.Cut along dashed lines on all four panels of carton. Remove end panels and lay side panels flat.
3.Check for any additional loose parts or cartons and remove.
Terminal
Terminal
TO ADJUST SEAT
Grasp adjustment handle (A) and pull up, slide seat to desired position and release adjustment handle.
7
