Immediatelyprepareyourtillerfor storage attheendof theseasonor if theunitwill
notbe usedfor 30 daysor more,,
,_kCAUTION: Never' store the tiller with gasoline in the tank inside a building where fumes may reach an open flame or spark. Allow the engine to cool before storing in any enclosure,
TILLER
o Clean entire tiller (See "CLEANING" in the Customer Responsibilities section of this manual).
o Inspect and replace belts, if necessary (See belt replacement instructions in the Service and Adjustments section of this manual)_
. Lubricate as shown in the Customer
Responsibilities section of this manual. o Be sure that all nuts, bolts and screws are securely fastened_ Inspect moving parts for damage, breakage and wear:,
Replace if necessary.
o ]buch up all rusted or chipped paint sur- faces; sand lightly before painting,.
ENGINE
FUEL SYSTEM
IMPORTANT: It is important to prevent
gum deposits from forrning in essential fuel system parts such as the carburetor, fuel filter, fuel hose, or tank during storage_ also, experience indicates that alcohol blended fuels (called gasohol or using ethanol or methanol) can attract moisture which leads to separation and formation of acids during storage. Acidic gas can dam- age the fuel system of an engine while in
storage.
o Drain the fuel tank.
o Start the engine and let it run until the fuel lines and carburetor are empty=
,,Never use engine or carburetor cleaner products in the fuel tank or permanent
damage may occur.
o Use fresh fuel next season.
NOTE: Fuel stabilizer is an acceptable alternative in minimizing the formation of fuel gum deposits during storage. Add sta- bilizer to gasoline in fuel tank or storage container. Always follow the mix ratio found on stabilizer container: Run engine
at least 10 minutes after adding stabilizer to allow the stabilizer to reach the carbure-
tor. Do not drain the gas tank and carbu- retor if using fuel stabilizer.
ENGINE OIL
Drain oil (with engine warm) and replace with clean oilo (See "ENGINE" in the Customer Responsibilities section of this manual)°
CYLINDERS
• Remove spark plug
°Pour 1 ounce (29 ml) of oil through spark plug hole into cylinder,
. Pull starter handle slowly several times to distribute oilo
° Replace with new spark plug.
OTHER
o Do not store gasoline from one season to another:
•ReplaCe your gasoline carl if your can starts to rust. Rust and/or dirt in your gasoline will cause problems.
o If possible, stere your unit indoors and
cover it to give protection from dust and dirt.
o Cover your unit with a suitable protective cover that does not retain moisture. Do
not use plastic. Plastic cannot breathe which allows condensation to form and
will cause your unit to rust, IMPORTANT: Never cover tiller while
engine and exhaust areas are still warm,
I16
