Your new tiller has been assembled at the factory with exception of those parts left unassembled for shipping purposes. To ensure safe and proper operation of your tiller all parts and hardware you assemble must be tightened securely, Use the correct tools as necessary to insure proper tightness.
TOOLS | REQUIRED FOR | ASSEMBLY | FRONT | |
| ||||
A socket wrench set will make assembly |
| |||
easier. Standard wrench sizes are listed. |
| |||
(t) | Utility knife |
|
| |
(t) | Wire | cutter |
|
|
(1) Tire | pressure gauge | LEFT | RIGHT | |
(1)Screwdriver
(1)Pair of pliers
(1)9/16" wrench
OPERATOR'S POSITION
When right or left hand is mentioned in this manual, it means when you are in
the operating position (standing behind tiller handles).
OPERATOR'S
POSITION
i,iii i,, NIH'1'= | I=" |
CONTENTS OF HARDWARE PACK
(2) Handle Locks |
| (1) Center Locknut | |
| |||
(1) Carriage | Bolt | ||
| |||
x I Gr. 5 | (1) Cable Clip | ||
|
|
(2) Hairpin Clips
(1) Pivot Bolt
(1) Flat Washer
13/32 x 1 x 11 Ga.
Extra Shear Pins & Clips
(1) Handle Lock Lever
5
