Craftsman 917.375012 owner manual Engine, To Adjust Handle, Carburetor, Rotate

Blade adapter Key Crankshaft

Lockwasher

Blade

Blade

bolt	Hardened	5,	\	\	,	_j
		',,,,
	washer	TrailinYedge				retainer

TO ADJUST HANDLE

The handle can be mounted in a high or

low position. The mounting holes in the bottom of lower handle are off center for

raising or lowering the handle.

1.Remove upper handle and all wire tie(s) securing cable(s) to lower handle.

2.Remove hairpin cotters from lower handle bracket mounting pin.

3.Squeeze lower handle in to remove it from mounting pins.

4.Turn lower handle over to raise or lower handle.

5.Squeeze lower handle in and position holes onto mounting pins on bracket.

6.Reassemble upper handle and all parts removed from lower handle.

Lower handle

ROTATE

ENGINE

ENGINE SPEED

Your engine speed has been factory set. Do not attempt to increase engine speed or it may result in personal injury. If you believe that engine is running too fast or too slow, take your mower to a Sears or other qualified service center for repair and adjustment.

CARBURETOR

Your carburetor is not adjustable. If your engine does not operate properly due to sus- pected carburetor problems, take your lawn mower to a Sears or other qualified service center for repair and/or adjustment.

IMPORTANT: Nevertamperwith the engine governor, which is factory set for proper en- gine speed. Overspeeding the engine above the factory high speed setting can be danger- ous. If you think the engine-governed high speed needs adjusting, contact a Sears or other qualified service center, which has proper equipment and experience to make any necessary adjustments.

15