all'CAUTION: Disconnect spark plug wire from spark plug and place wire where it cannot come in contact with plug.
•Clean the underside of your lawn mower
by scraping to remove
•Clean engine often to keep trash from
accumulating, A clogged engine runs hotter and shortens engine life,
•Keep finished surfaces and wheels free of all gasoline, oi!, etco
•We do not recommend using a garden hose to clean lawn mower unless the
electrical system, muffler, air filter and carburetor are covered to keep water out° Water in engine can result in short- ened engine life.
CLEAN UNDER DRIVE COVER
Clean under drive cover at least twice a season, Scrape underside of cover with putty knife or similar tool to remove any
WATER WASHOUT FEATURE
Your lawn mower is equipped with a fitting that allows quick and easy cleaning of the underside of the housing, To use this
feature, proceed as follows:
1, Move lawn mower to an area of cut grass or another hard surface.
NOTE: Water, grass and other debris will drain from beneath the mower housing during the washout process,
2, Remove grass catcher and discharge chute assembly from lawn mower.
3, Close mulcher door (if equipped)_
4.Connect a garden hose to the fitting where shown.
IMPORTANT; Be sure the garden hose is not routed under the lawn mower housing or entangled in the wheels,
5_ Turn on water supply and check for leaks at the fitting,
if no leaks are present, start engine (as described in the Operation section of this manual) and let engine run until the under- side of the lawn mower is clean.
_1=WARNING: Do not engage the drive system during the washout process_
6, Shut off the engine,
7, Shut off water supply and remove hose from fitting,
CAUTION: Do not remove hose from fitting while engine is running. Water in engine can result in shortened engine life,
8Start engine (as described in the Op- eration section of this manual) and let
engine run for a full minute to remove excess water from mower,.
!5
