SERVICE
TO ADJUST HANDLE (See Figs. 15 Thru 17)
Your tawn mower handle can be raised or lowered for your mowing comfort. Four (4) positions are available: high, medium high, medium tow and low. Handles are shipped mounted in the medium tow position.
-To change from medium low to medium high position, the upper and lower handle sections will have to be turned Over (See Fig. 15B),
oRemove the controls and operator presence control bar from the upper handle.
*Remove the starter rope guide from the lower handle.
-Remove hairpin cotters,
°Disconnect the lower handte from the handfe brackets (See Fig. 17).
. Turn the handle over and reassemble the hairpin cotters that have been removed,
. Reassemble the starter rope guide.
. Reassemble the controlS and the operator presence controt bar to the upper handle.
CAUTION: The operator presence con- trol bar mu st pivot freely to permit blade brake engagement when control bar is
released, Do not over tighten the fasteners holding the controls to the upper handle.
To change from medium low to high position only the upper handle section will have to be turned over (See Fig. 16A).
To change from medium low to low position, only the lower handle section will have to be turned over (See Fig. 16B).
ADJUSTMENTS
SHIPPING POSITION
MEDIUM LOW
FiG. 15A
MEDIUM HIGH
FIG. 15B
ENGINE
ENGINE SPEED
Your engine speed has been factory set. Do not attempt to increase engine spee d or it may result in personal injury. If you believe that the engine is running too fast ortoo slow, take your lawn mower to an authorized service center for repair and adjustment.
CARBURETOR
Your carburetor has a
FIG. 16A
SQUEEZE
TO REMOVE
HAIRPIN CLIP
FIG. 17
FIG. 16B
LOWER HANDLE
HANDLE
BRACKET
16
