TO CHANGE ENGINE OIL
NOTE: Before tipping lawn mower to drain oil, drain fuel tank by running engine until fuel tank is empty.
•Disconnect spark plug wire from spark plug and place wire where it cannot come in contact with spark plug.
•Remove engine oil cap; lay aside on a clean surface.
•Tip lawn mower on its side as shown and drain oil into a suitable container. Rock
lawn mower back and forth to remove any oil trapped inside of engine.
•Wipe off any spilled oil on lawn mower and on side of engine.
•Fill engine with oil. Fill only to the "FULL" line on the dipstick. DO NOT overfill.
•Replace engine oil cap.
•Reconnect spark plug wire to spark plug.
Container
AIR FILTER
Your engine will not run properly and may be damaged by using a dirty air filter. Replace the air filter every year, more
often if you mow in very dusty, dirty conditions. Do not wash air filter.
TO CHANGE AIR FILTER
•Remove the air filter by turning clock-
wise to the stop and pull away from collar.
•Remove filter from inside of cover.
•Clean the inside of the cover and the collar to remove any dirt accumulation.
•Insert new filter into cover.
•Put air filter cover and filter into collar aligning the tab with the slot.
•Push in on cover and turn counterclock- wise to tighten.
MUFFLER
Inspect and replace corroded muffler as it
could create a fire hazard and/or damage.
SPARK PLUG
Change your spark plug each year to make your engine start easier and run better. Set spark plug gap at .030 inch.
CLEANING
IMPORTANT: For best performance, keep mower housing free of
*q,CAUTION: Disconnect spark plug wire from spark plug and place wire where it cannot come in contact with the spark plug.
•Turn lawn mower on its side. Make sure air filter and carburetor are up. Clean the underside of your lawn mower by scraping to remove
•Clean engine often to keep trash from accumulating. A clogged engine runs hotter and shortens engine life.
•Keep finished surfaces and wheels free of all gasoline, oil,etc.
•We de not recommend using a garden hose to clean lawn mower unless the
electrical system, muffler, air filter and carburetor are covered to keep water out. Water in engine can result in shortened
engine life.
CLEAN UNDER DRIVE COVER
Clean under drive cover at least twice a season. Scrape underside of cover with putty knife or similar tool to remove any
Collar
Clockwise
|
| to |
|
Slot |
| Remove | |
|
|
| |
|
| Turn |
|
Air Filter | Tab | Counter- | to |
| Air Filter | Clockwise | |
| Cover | Tighten | 13 |
