ENGINE SPEED
Your engine speed has been factory set. Do not attempt to increase engine speed or it may result in personal injury. If you believe that the engine is running too fast or too slow, take your lawn mower to an authorized service center for repair and adjustment.
CARBURETOR
Your carburetor has a
•lawn mower to an authorized service center for repair and/or adjustment.
IMPORTANT: Never tamper with the engine governor, which is factory set for proper engine speed. Overspeeding the engine above the factory high speed setting can be dangerous, if you think the
TO ASSEMBLE GRASS CATCHER
•Insert leg of tubular frame through front opening of grass catcher and thread frame into sewn hem of bag.
NOTE: Keep bag hem gathered on the straight leg of the tubular frame.
•When frame comes out the other end of
sewn hem, immediately work the end of frame down inside the bag as shown in inset.
•Slide sewn hem evenly around the tubular frame until both ends of frame
are exposed out of the front opening.
•Assemble lower frame to tubular frame as shown. Be sure handle is outside of
bag and frames are fully seated as shown in inset.
•Slip vinyl bindings over frame.
NOTE: If vinyl bindings are too stiff, hold them in warm water for a few minutes. If
bag gets wet, let it dry before using.
• Close the flip lid. Flip lid must be closed while operating lawn mower.
•(:_CAUTION: Do not run your lawn mower without clipping deflector or approved grass catcher in place. Never attempt to operate the lawn mower with the rear door removed or propped open.
| Sewn |
|
Tubular frame | hem _ | \ |
Sewn hem | Flip lid |
Lower frame
(Frames must be
fully seated)
Tubular frame
Lower frame handle
15
