PRODUCT | SPECIFICATIONS |
|
|
|
| ||
MODEL | NUMBER | 917.377582 |
|
| |||
SERIAL | NUMBER |
|
|
|
| ||
DATE OF PURCHASE |
|
|
|
| |||
HORSEPOWER: |
| 6.75 |
|
|
| ||
DISPLACEMENT: | 12.56 | CU. IN. |
| ||||
_ASOLINE | CAPACITY/TYPE: | 1.5 QUARTS |
|
| |||
|
|
|
| UNLEADED | REGULAR | ||
OIL TYPE | SAE 30 (ABOVE 32°F) | ||||||
|
|
|
| SAE | (BELOW | 32°F) | |
OIL CAPACITY: |
| 27 OZS. |
|
| |||
SPARK | PLUG(GAP: .030") | CHAMPION | RJ19LM | OR J19LM | |||
VALVE | CLEARANCE: | INTAKE: | |||||
|
|
|
| EXHAUST: | .004 | ||
SOLID | STATE | IGNITION |
|
|
|
| |
AIR GAP: |
|
| .0125 | IN. |
|
| |
BLADE | BOLT TORQUE: | FT. LBS. |
| ||||
The model and serial numbers
lawn mower housing.Record provided above.
will be found on a decal attached to the rear of the both serial number and date of purchase in space
LAWN MOWER
Always observe safety rules when performing
any maintenance.
TIRES
•Keep tires free of gasoline, oil, or insect control chemicals which can harm rubber.
•Avoid stumps, stones, deep ruts, sharp objects and other hazards that may cause tim damage.
BLADE CARE
For best results, mower blade must be kept sharp. Replace bent or damaged blades.
TO REMOVE BLADE
•Disconnect spark plug wire from spark plug and place wire where it cannot come in contact with spark plug.
•Turn lawn mower on its side. Make sure air filter and carburetor are up.
•Use a wood block between blade and mower housing to prevent blade from turning when removing blade bolt.
•Protect your hands with gloves and/or wrap blade with heavy cloth.
•Remove blade bolt by turning counter- clockwise.
•Remove blade and attaching hardware
(bolt, lock washer and hardened washer).
NOTE: Remove the blade adapter and check the key inside hub of blade adapter. The key must be in good condition to work properly. Replace adapter if damaged.
TO REPLACE BLADE
•Position the blade adapter on the engine crankshaft. Be sure key in adapter and crankshaft keyway are aligned.
•Position blade on the blade adapter aligning the two (2) holes in the blade with the raised lugs on the adapter.
•Be sure the trailing edge of blade (opposite sharp edge) is up toward the engine.
•Install the blade bolt with the lock washer and hardened washer into blade adapter and crankshaft.
•Use block of wood between blade and lawn mower
•The recommended tightening torque is
11
