Craftsman 917.377582 owner manual Cylinder, ontrol cables

Models: 917.377582

1 30
Download 30 pages 40.68 Kb
Page 16
Image 16
.'ontrol cables.

"nmediately prepare your lawn mower for torage at the end of the season or if the unit ,,illnot be used for30 days or more.

.AWN MOWER

Vhen lawn mower is to be stored for a period ,f time, clean it thoroughly, remove all dirt, trease, leaves, etc. Store in a clean, dry area.

Clean entire lawn mower (See "CLEANING" in the Maintenance section of this manual). Lubricate as shown in the Maintenance section of this manual.

Be sure that all nuts, bolts, screws, and pins are securely fastened. Inspect moving pads for damage, breakage and wear. Replace if necessary.

Touch up all rusted or chipped paint

surfaces; sand lightly before painting.

"IANDLE

(ou can fold your lawn mower handle for ;torage.

Squeeze the bottom ends of the lower handle toward each other until the lower handle clears the handle bracket, then move handle forward.

,Loosen upper handle mounting bolts enough to allow upper handle to be folded back.

MPORTANT: When folding the handle for storage or transportation, be sure to fold the _andle as shown or you may damage the

.'ontrol cables.

,When setting up your handle from the storage position, the lower handle will automatically lock into the mowing position.

LowerHandle

HandleBracket

Squeeze tofold

Hairpin

Cotter

Operator Presence

Control Bar

Fold Backward

Mowing Position

Fold FonNard

For Storage

Lower Handle

ENGINE

FUEL SYSTEM

IMPORTANT: It is important to prevent gum deposits from forming in essential fuel system pads such as carburetor, fuel filter, fuel hose, or tank during storage. Also, experience indicates that alcohol blended fuels (called gasohot or using ethanol or methanol) can attract moisture which leads to separation and formation of acids during storage. Acidic gas can damage the fuel system of an engine while in storage.

Drain the fuel tank.

Start the engine and let it run until the fuel lines and carburetor are empty.

Never use engine or carburetor cleaner products in the fuel tank or permanent damage may occur.

Use fresh fuel next season.

NOTE: Fuel stabilizer is an acceptable

alternative in minimizing the formation of fuel gum deposits during storage. Add stabilizer to gasoline in fuel tank or storage container. Always follow the mix ratio found on stabilizer container. Run engine at least 10 minutes after adding stabilizer to allow the stabilizer to reach the carburetor. Do not drain the gas tank and carburetor if using fuel stabilizer.

ENGINE OIL

Drain oil (with engine warm) and replace with clean engine oil. (See "ENGINE" in the Maintenance section of this manual).

CYLINDER

Remove spark plug.

Pour one ounce (29 ml) of oil through spark plug hole into cylinder.

Pull starter handle slowly a few times to distribute oil.

Replace with new spark plug.

16

Page 16
Image 16
Craftsman 917.377582 owner manual Cylinder, ontrol cables