PRODUCT SPECIFICATIONS |
|
|
SERIAL NUMBER: |
|
|
DATE OF PURCHASE: |
|
|
SASOUNE CAPACITY/TYPE: | 1.6 QUARTS | |
| UNLEADED | REGULAR |
31LTYPE | SAE 30 (ABOVE 32°F) | |
| SAE | (BELOW 32°F) |
OIL CAPACITY: | 20 OZS. |
|
SPARK PLUG(GAP: .030") | CHAMPION | RJ19LM OR J19LM |
BLADE BOLT TORQUE: | ||
The model and sadal numbers will be found on a decal attached to the rear of the lawn mower housing, Record both sedal number and date of purchase in space provided above.
LAWNMOWER
Alwaysobservesafetyroleswhenperfon_ ingany maintenance.
TIRES
•Keeptiresfreeofgasallee,oil,or insect controlchemicalswhichcanharmrubber.
•Avoidstumps,stones,deepruts,sharp objectsandotherhazards_ maycause tiredamage.
BLADE CARE
For bestresults,mowerblademust be
keptsharp. Replacebent or damaged blades.
TO REMOVE BLADE
1.Disconnect spark plug wire from spark plug and place wire where it cannot come in contact with spark plug.
2.Turn lawn mower on its side. Make sure air filter and carburetor are up.
3.Use a wood block between blade and
mower housing to prevent blade from turning when removing blade bolt.
NOTE: Protect your hands with gloves and/or wrap blade with heavy cloth.
4.Remove blade bolt by turning counter- clockwise.
5.Remove blade and attaching hard- ware (bolt. lock washer and hardened
washer).
NOTE: Remove the blade adapter and check the key inside hub of blade adapter. The key must be in good condi- tion to work propedy. Replace adapter if damaged.
TO REPLACE BLADE
1.Position the blade adapter on the engine crankshaft. Be sure key in adapter and crankshaft keyway are aligned.
2.Position blade on the blade adapter aligning the two (2) holes in the blade with the raised lugs on the adapter.
3.Be sure the trailing edge of blade (opposite sharp edge) is up toward the engine.
4.Install the blade bolt with the lock washer and hardened washer into blade adapter and crankshaft.
5.Use block of wood between blade and lawn mower housing and tighten the
blade bolt, turning clockwise.
•The recommended tightening torque is
IMPORTANT: Blade belt is grade 8 heat treated.
Crankshaft
Key_keyway
Blade | shaft |
bolt | \ |
washer | Trailingedge Bladeadapter |
11
