Craftsman 919.15519 owner manual Before Using Your Spray, To Use Spray Gun

F_q_,_	USE OF A FACE		4. Turn air valve control knob
	MASK IS		clockwise until it stops, do not
RECOMMENDED	TO PREVENT IN-		force.
HALATION OF TOXIC		MATERIAL.
Before Using	Your	Spray	Air
			Valve
Gun

1.Set up spray gun as described in the "How to Set Up Spray Gun" paragraph in the "AssembIy" section of this manual.

To Use Spray Gun

1.The position of the air cap horns wilt determine the fan spray pattern. Loosen air cap and rotate horns to achieve desired pattern. Tighten air cap.

Horizontal position

_ Vertical position

2.Turn fluid control knob clockwise

untit it stops, do not force. This wilt shut off the fluid flow. NOTE:

The fluid or density of "fan spray" is contretied by fluid control knob.

3.Turn pattern control knob counteretockwise untit first thread

is flush with gun body. NOTE: Air flew is contreIted by pattern con- trol knob.

_DO	NOT turn pattern
	control knob or fluid

control knob counter clockwise after

first thread is flush with the gun body. They are under pressure when the gun is triggered and could leave the gun with force.

first thread flush Pattern

Knob

Ruid

5.Adjust air pressure to 40 psi at regulator.

_DO	NOT exceed 45
	psi.
I_-_	Pressure	may vary
	according	to

viscosity of material used. Maximum working pressure of gun is 45 psi.

DO NOT EXCEED PRESSURE LIMIT OF GUN OR ANY OTHER COMPO- NENT IN SYSTEM!

6.Depress spray gun trigger and gradually turn the fluid contret knob counterclockwise until desired fluid flow is reached.

Tngger gun quickly, one second on-off to test pattern.

NEVER point spray gun at self or any

other person. Accidental discharge of material may result in serious injury.

To adjust spray pattern and fluid pressure:

•TO adjust the fluid, turn fluid con- troi knob counterclockwise to in- crease or clockwise.

•To adjust the air flow, turn pattern contret knob counteretockwise to increase or clockwise to de- crease.

•To fine tune the air flew, turn air vatve control knob counterclock-

wise to increase, or clockwise to decrease.

IMPORTANT: Always clean gun after each use. See "Maintenance" section

for correct procedure.

9-ENGD29783