Craftsman 919.722020 owner manual How to Stop, Before First Start-up

Female Tire Chuck: Attaches to the hose end to be used to inflate tires. Note: To ensure correct tire pressure use a tire pressure gauge.

Hose Adapter: Attaches to hose end to allow the use of accessories. Blow Gun Adapter: Attaches to hose end or blow gun (sold separately, not shown) to allow the inflating needle to be used.

Inflating needle: Attaches to blow gun adapter to be used to inflate sport balls.

Tapered Inflator: Attaches to hose adapter or blow gun (sold separately) to be used to inflate toy inflatables/air mattresses.

Extension Tube: Attaches to hose adapter or blow gun (sold separately) to be used for air blowing, drying, and for specialized inflating.

Drain Valve (not shown): The drain valve is located at the base of the air tank and is used to drain condensation at the end of each use. Cooling System (not shown): This compressor contains an advanced design cooling system. At the heart of this cooling system is an engineered fan. It is perfectly normal for this fan to blow air through the vent holes in large amounts. You know that the cooling system is working when air is being expelled.

Air Compressor Pump (not shown): Compresses air into the air tank. Working air is not available until the compressor has raised the air tank pressure above that required at the air outlet.

Check Valve (not shown): When the air compressor is operating, the check valve is "open", allowing compressed air to enter the air tank. When the air compressor reaches "cut-out" pressure, the check valve "closes", allowing air pressure to remain inside the air tank.

How to Use Your Unit

How to Stop:

1.Set the Off/Auto switch to "OFF".

Before First Start-up

Break-in Procedure

Risk of Unsafe Operation. Serious

damage may result if the following break-in instructions are not closely followed.

This procedure is required before the air compressor is put into service.

1.Make sure the Off/Auto switch is in the "OFF" position.

2.Turn the regulator knob counterclockwise until it stops.

3.Plug the power cord into the correct branch circuit receptacle. (Refer to Voltage and Circuit Protection paragraph in the Installation section of this manual.)

4.Open the drain valve fully (counterclockwise) to permit air to escape and prevent air pressure build up in the air tank during the break-in period.

5.Move the Off/Auto switch to "AUTO" position. The compressor will start.

6.Run the compressor for 15 minutes. Make sure the drain valve is open and there is minimal air pressure build-up in tank.

7.After 15 minutes, close the drain valve (clockwise). The air receiver will fill to "cut-out" pressure and the motor will stop.

The compressor is now ready for use.

D29495 14- ENG