Craftsman C944.511591 CoverscrewholesInserttwo, Screwsintothescrewholes, Wrench

2.

Positiononeofthebracketcovers

1,

Place

the

upper

shoulder

strap

undertheuppershaftandalignthe

clamp

over

the

upper shaft

above

mountingbracketandthebracket

the handlebar.

coverscrewholesInserttwo.

2.

Position the

lower

shoulder

strap

3.

screwsintothescrewholes.

clamp

under

the

upper shaft and

Securethemountingbracketby

align

the

upper

and

lower

clamp

tighteningthescrewswiththehex

screw

holes

(use spacer tabs be-

4.

wrench.

tween

upper

and

lower clamps if

Locatethedecalonthehandlebar.

necessary

to secure

clamp,

i.e. for

ThisdecalincludesanarrowPosi.-

1" diameter

upper

shaft).

tionthehandlebarwiththemount-

5.

ingbracketattheendofthearrow.

Upper

Shoulder

Positionthesecondbracketcover

Clamp

overthehandlebarAlignthemount.-

ingbracketandthebracketcover

POWERHEAD

screwholesAgainmakesurethe.

END

6.

handlebarisattheendofthearrow.

Inserttwoscrewsandhandtighten

onlyBesurethehandlebaris.

installedcorrectly;then,tighteneach

Lower

Shoulder

l

END

screwsecurelywiththehexwrench. Strap

Clamp

ATTACHMENT

Screws

SHOULDER STRAP ASSEMBLY

WARNING: Proper shoulder strap

and handlebar adjustments are required

before use. The shoulder strap clamp must be installed as shown above the

handlebar on the upper shaft (power- head end of unit).

NOTE: The lower shoulder strap clamp has two spacer tabs attached. These tabs are provided to adapt this attachment for use with powerheads that have a 1" diameter upper shaft (the shoulder strap clamp will not tight- en down securely on the 1" diameter upper shaft without using these spacer tabs). The tabs must be broken off

completely before use and placed over the screw holes on the lower shoulder

strap clamp. These tabs are not need-

ed for powerheads with a 7/8" upper shaft.

LOWER SHOULDER STRAP CLAMP

3.Insert two screws into the screw holes.

4.Secure shoulder strap clamp by

tightening screws with the hex wrench.

5.Insert your right arm and head through the shoulder strap and al- low it to rest on your left shoulder. Make sure the danger sign is on your back and the hook is to the

right side of your waist.

NOTE: A one-half twist is built in the

shoulder strap to allow the strap to rest flat on the shoulder.

6.Adjust the strap, allowing the hook to be about 6 inches below the

waist.

7.Fasten the strap hook to the upper clamp and lift the tool to the oper- ating position.

8.Try on shoulder strap and adjust for fit and balance before starting the

engine or beginning a cutting opera- tion.

NOTE: It may be necessary to

relocate the shoulder strap clamp on the shaft for proper balancing of unit.

41;_L-_,_- Spacer Tabs positioned for use on 1" diameter

upper shaft