OPERATION
USING THE CLEAN=OUT TOOL (See Fig. 15)
In certain snow conditions, the discharge chute may be- come clogged with ice and snow. Use the
When cleaning, repairing, or inspecting, make certain all controls are disengaged and the au= get/impeller and all moving parts have stopped.
Disconnect the spark plug wire and keep the wire away from the spark plug to prevent ac= cidental starting.
•Release the auger control lever and shut offthe engine.
•Remove the
After the packed snow has been dislodged, return the clean- out tool to it'smounting clip by pushing it into the clip.
•Make sure the discharge chute is pointed in asafe direc- tion (no vehicles, buildings, people, or other objects are in the direction of discharge) before restarting the engine.
•Restart the engine, then squeeze the auger control lever to the handle to clear snow from the auger hous- ing and the discharge chute.
DISCHARGE CHUTE | /[_ |
TOOL
FIG. 15
TO MOVE FORWARD AND BACKWARD (See Fig. 16)
the snow thrower, is controlled by the traction drive control lever located on the left side handle.
•Squeeze traction drive control lever to handle to engage the drive system.
•Release traction drive control lever to stop the forward or reverse movement of the snow thrower.
SPEED and DIRECTION are controlled by the drive speed control lever.
Press downward on the speed control lever and move lever to desired position BEFORE engaging the trac-
tion drive control lever. Be sure lever springs back and locks into desired position.
CAUTION: Do not move speed control lever when traction drive control lever is engaged. Damage to the snow thrower can result.
Slower speeds are for heavier snow and faster speeds are for light snow and transporting the snow thrower. It is recommended that you use a slower speed until you are familiar with the operation of the snow thrower.
NOTE: When both traction drive and auger control levers are engaged, the traction drive control lever will lock the auger control lever in the engaged position. This will allow you to release your right hand from the handle and adjust the discharge chute direction without interrupting the snow throwing process.
TRACTION DRIVE
LEVER
DRaVE SPEED
CONTROLLEVER
FIG. 16
POWER STEERING OPERATION (See Fig. 17)
Steering triggers are used to assist in steering your snow thrower. The triggers are located on the underside of each handle. When a trigger is squeezed, it disen-
gages the drive wheel on that side of snow thrower and allows it to turn in that direction.
•To turn left - squeeze left side trigger.
•To turn right - squeeze right side trigger.
LH TURN RH TURN
TRIGGER TRIGGER
FIG. 17
12
