Craftsman 944.528398 owner manual Operati, Meets A.N.S.I. Safety Requirements

OPERATI

				DISCHARGE	DEFLECTOR
GASOLINE		AUGER	DRIVE	CHUTE	REMOTE
FILLER	CAP	CONTROL	SPEED	CONTROL	CONTROL
	ELECTRIC	LEVER	CONTROL	LEVER	LEVER
MUFFLER	START		LEVER

		BUTTON
		RECOIL
		,(AUXILIARY)		TRACTION
CHOKE		STARTER	CHUTE	DRIVE
CONTROL		HANDLE	DEFLECTOR	CONTROL
		ON / OFF		LEVER
		SWITCH
PRIMER
SAFETY				=H TURN
				TRIGGER
IGNiTiON
KEY
	THROTTLE	DISCHARGE
		CHUTE
		CLEAN=OUT		HANDLE
		TOOL
				KNOB
				MUFFLER
NOTE: iTEMS ABOVE
ARE SHOWN iN
THEIR	TYPICAL			TOOLBOX
LOCATION ON THE
ENGINE.	ACTUAL
LOCATION MAY
VARY WiTH THE
ENGINE	ON YOUR

UNIT.

P LATE

AUGERS

FiG. 10

MEETS A.N.S.I. SAFETY REQUIREMENTS

Our snow throwers conform to the standards of the American National Standards Institute.

Toolbox = used to store spare shear bolts, Iocknuts and wrench.

Safety ignition key = must be inserted for the engine to start and run. Remove when snow thrower is not in use.

Electric start button - used for starting the engine.

Recoil (auxiliary) starter handle - used for starting the engine.

LH and RH turn triggers =used to steer the snow thrower.

Drive speed control lever = used to select forward or reverse motion and speed of snow thrower.

Primer = pumps additional fuel from the carburetor to the cylinder for use when starting a cold engine.

ON / OFF switch - used to STOP the engine.

Choke control - used for starting a cold engine.

Throttle/engine control - used to select either FAST or SLOW engine speed and to STOP the engine.

Traction drive control lever - used to engage power-pro- pelled forward or reverse motion of snow thrower.

Auger control lever - used to engage auger motion (throw

snow).

Deflector remote control lever = used to change the distance the snow is thrown.

Discharge chute control lever = used to change the di- rection the snow is thrown.

Skid plate = used to adjust height of scraper bar from the ground.

10