Craftsman 944.602951 owner manual To Roll Tractor OFF Skid See Operation

ASSEMBLY

Connect BLACK groundingcable to negative (-) terminal with remaining hex bolt and keps nut. Tighten securely.

		DISCARD TERMINAL
		PROTECTIVE CAPS
		KEPS
TERMINAL	!i	HEX BOLT
		NU_

POSITIVE (BED)	NEGATIVE (BLACK)
CABLE	CABLE
	RG. 2
SEAT PAN

FIG. 3

NSTALL SEAT (See Fig. 4)

\d just seat before tightening adjustment knob.

Remove adjustment knob and flatwasher securing seat to cardboard packing and set aside for assembly of seat to tractor.

Pivot seat upward and remove from the cardboard packing. Remove the cardboard packing and discard. Place seat on seat pan so head of the shoulder boltsare positioned over large slotted holes in pan.

Push down on seat to engage shoulder boltsin slots and pull seat towards rear of tractor.

Pivot seat and pen forward and assemble adjustment knob end flat washer loosely. Do not tighten.

Lower seat into operating position and sit on seat.

Slide seat until a comfortable position is reached which allows you to press clutch/brake pedal all the way down.

Get off seat without moving its adjusted position. Raise seat and tighten adjustment knob securely.

SEAT

SEAT

PAN_

SHOULDER

BOLTS

FLAT WASHER

ADJUSTMENTm W

KNOB

FIG. 4

NOTE: You may now roll or ddve your tractor off the skid.

Follow the appropriate instruction below to remove the tractor from the skid.

TO ROLL TRACTOR OFF SKID (See Operation

section page 10 for location and function of controls)

•Press liftlever plunger and raise attachment liftlever to its highest position.

•Release parkingbrake bydepressing clutctVorakepedal.

•Place freewheel control in freewheeling position to disengage transmission (See "TO TRANSPOR'I" inthe

Operation section of this manual).

•Roll tractor forward off skid.

•Remove banding holding deflector shield up against tractor.

TO DRIVE TRACTOR OFF SKID (See Opera- tion section page 10 for location and function

of controls)

_WARNING: Before starting, read, understand and follow

all instructions in the Operation section of this manual. Be sure tractor is in a well-ventilated area. Be sure the area in

front of tractor is clear of other people and objects.

•Be sure all the above assembly steps have been completed.

•Check engine oil level and fillfuel tank with gasoline.

•Place freewheel control in "transmission engaged" posi- tion.

•Sit on seat in operating position, depress clutch/brake pedal and set the parking brake.

•Place motion control lever in neutral (N) position.

7