Craftsman 944.602951 owner manual cov.WASRERSj, Service And Adjustments, To Replace Headlight Bulb

SERVICE AND ADJUSTMENTS

FRONT WHEEL CAMBER

The front wheel camber is not adjustable on your tractor. If damage has occurred to affect the front wheel camber, contact your neerest authorized service center/department.

TO REMOVE WHEEL FOR REPAIRS (See Fig. 28)

PosrnvE TERMINAL NEGATIVETERMINAL

•Block up axle securely.

•Remove axle cover, retaining ring and washerstoallow wheel removal (rearwheel contains a square key - Do not lose).

•Repairtireand reassemble.

•Onrearwheelsonly: aligngroovesinrearwheelhuband axle. Insert square key.

•Replace washers and snap retaining ringsecurely inaxle groove.

•Replace axle cover.

CHASSIS

POSITIVE TERMINAL

BATTERY

TERMINAL

NOTE: To seal tire punctures and prevent flat tires due to slow leaks, tire sealant may be purchased from your local parts dealer. Tire sealant also prevents tire dry rot and corrosion.

	RETAINING r_ __.'_,
AXLE	.,.G\	I\
	\	I ._11_--_ "_.111

cov.WASRERSj 1

SQUARE KEY

(REAR WHEEL ONLY)

FIG. 28

TO START ENGINE WITH A WEAK BATrERY (See Fig. 29)

CAUTION: Lead-acid batteries generate explosive gases. Keep sparks, flame and smoking materials away from bat- teries. Always wear eye protection when around batteries.

If your battery is too weak to start the engine, it should be recharged. If "jumper cables" are used for emergency starting, follow this procedure:

IMPORTANT: YOUR TRACTOR IS EQUIPPED WITH A 12 VOLT NEGATIVE GROUNDED SYSTEM. THE OTHER

VEHICLE MUST ALSO BE A 12 VOLT NEGATIVE GROUNDED SYSTEM. DO NOT USE YOUR TRACTOR BATTERY TO START OTHER VEHICLES.

TO ATI'ACH JUMPER CABLES -

•Connect each end of the REDcabletothe POSITIVE (+) terminal of each battery, taking care not to short against chassis.

Connect one end of the BLACK cable to the NEGATIVE (-) terminal of fully charged battery.

Connect the other end of the BLACK cable to _od CHASSIS GROUND, away from fuel tank and battery.

TO REMOVE CABLES, REVERSE ORDER -

• BLACK cable first from chassis and then from the fully charged battery.

• RED cable last from both batteries.

22

RG. 29

TO REPLACE HEADLIGHT BULB

•Raise hood.

•Pullbulb holder out ofthe hole inthe backside ofthe gdlL

•Replace bulb in holder and push bulb holder securely back into the hole in the backside of the grill.

•Close hood.

INTERLOCKS AND RELAYS

Loose or damaged wiring may cause your tractor to run poorly, stop running, or prevent it from starting.

Check wiring. See electricalwiringdiagram inthe Repair Parts section.

TO REPLACE FUSE

Replace with 20 amp automotive-typeplug-infuse. The fuse holder is located behind the dash.

TO REMOVE HOOD AND GRILL ASSEMBLY (See Fig. 30)

•Raise hood.

•Unsnap headlight wire connector.

Stand in front oftractor. G rasp hood at sides, tilt toward engine and lift off of tractor.

•To replace, reverse above procedure.

HEADLIGHT , WIRE

CONNECTOR

FIG. 30