BATTERY PACK/CHARGER

The battery pack and charger are not included with your worklight. They are both sold separately. When purchasing, use the following information:

MODEL NO, BATTERY PACK CHARGER

973,113900 Item No. 9_11378 Item No. 9_11379

(1323509)(1426101 )

BATTERY PACK

The battery pack for your worklight has been shipped in a low charge condition to prevent possible prob- lems. Therefore, you should charge it overnight prior

tO use.

Note: Batteries will not reach full charge the first time they are charged. Allow several cycles (operating worklight followed by recharging) for batteries to become fully charged.

CHARGING BATTERY PACK

See Figure 1.

Charge battery pack only with the recommended charger.

Make sure power supply is normal household voltage, 120 volts, 60 Hz, AC only.

Connect charger to power supply.

Place battery pack in charging stand. Align raised rib on battery pack with groove in charging stand. See Figure 1.

Press down on battery pack to be sure contacts on battery pack engage properly with contacts in charging stand.

The charge indicator light (LED), located on the charging stand, will light up red and glow when the charger is properly connected to power supply. This light indicates the charger is operating properly. It will remain on until battery pack is

BATTERYPACKSHOWN

IN CHARGINGSTAND

RED LIGHT (LED)

removed from charging stand or charger is discon- nected from power supply.

Note: If charger does not charge battery pack, return battery pack and charger to your nearest Sears Repair Center for electrical check.

After normal usage, 3 hours or less of charging time is required to fully recharge battery pack. Note: If battery pack is completely discharged, 6 hours or longer of charging time is required to fully recharge battery pack.

The battery pack will become slightly warm to the touch while charging. This is normal and does not indicate a problem.

Do not place charger in an area of extreme heat or cold. It will work best at normal room tempera- ture.

When batteries become fully charged, unplug charger from power supply and remove the battery pack.

IMPORTANT INFORMATION FOR RECHARG-

ING HOT BATTERIES

When using your worklight continuously, the batteries in your battery pack will become hot. You should let a hot battery pack cool down for approximately 30 minutes before attempting to recharge.

Note: This situation only occurs when continuous use

of your worklight causes the batteries to become hot. It does not occur under normal circumstances. Refer

to "CHARGING BATTERY PACK" for normal re- charging of batteries. If the charger does not charge your battery pack under normal circumstances, return both the battery pack and charger to your nearest Sears Repair Center for electrical check.

CHARGER

CHARGINGSTAND

Fig. 1

Page 4
Image 4
Craftsman 973.113900 Battery PACK/CHARGER, Model NO, Battery Pack Charger, Charging Battery Pack, Charger Chargingstand