RULES FOR SAFE OPERATION (Continued)

Do not expose to rain or snow.

To reduce the risk of damage to charger body and cord, pull by charger body rather than cord when disconnecting charger.

An extension cord should not be used unless

absolutely necessary. Use of improper extension cord could result in a risk of fire and

electric shock. If extension cord must be used, make sure:

a.That pins on plug of extension cord are the same number, size and shape as those of plug on charger.

b.That extension cord is properly wired and in good electrical condition; and

c.That wire size is large enough for AC ampere

rating of charger as specified below:

Cord Length (Feet) 25ft. 50ft. 100ft. 150ft.

Cord Size (AWG) 16 16 16 14 Note: AWG = American Wire Gage

CHARGING YOUR WORKLIGHT

The battery pack and charger are not included with this worklight. They are both sold separately• If you decide to purchase a battery pack and charger, use battery pack part number 975284-001 and charger part number 975283-001.

TO CHARGE BATrERY PACK:

Charge battery pack only with the charger recom- mended•

Make sure power supply is normal house voltage, 120 volts, 68 hz, AC only.

Connect charger to power supply.

Place battery pack in charger then press down on battery pack to be sure contacts on battery pack engage properly with charger contacts•

Red light should turn on.

When battery pack is fully charged, the red light will turn off and the green light will turn on.

TO INSTALL/REMOVE BATTERY PACK

See Figure 1.

Use 18.0 volt battery pack part number 975284-001 only.

Begin with a fully charged battery pack.

Note: After normal usage, the battery pack requires 1 hour of recharge time.

Orient battery pack so that raised rib on battery pack aligns with groove inside worklight. Battery

pack is designed to fit only one way in light handle•

_

DO NOT OPERATE CHARGER WITH A DAMAGED CORD OR PLUG. If damaged, have replaced immediately by a qualified serviceman. Do not operate charger if it has received a sharp blow, been dropped, or otherwise damaged in any way; take it to a qualified serviceman.

Do not disassemble charger; take it to a qualified serviceman when service or repair is required.

Incorrect reassembly may result in a risk of electric shock or fire.

To reduce the risk of electric shock, unplug charger from outlet before attempting any

maintenance or cleaning. Turning off controls will not reduce this risk.

Do not use charger outdoors.

Disconnect charger from power supply when not in

use,

SAVE THESE INSTRUCTIONS. Review them

frequently and use them to instruct others who

may use this light. If you loan someone this light, loan them these instructions also.

Insert battery pack, making sure latches on each side of battery pack snap in place and battery pack is secure in light before use.

CAUTION: When placing battery pack in your light, be sure raised rib on battery pack aligns

with groove inside light handle and latches snap in place properly. Improper assembly of battery pack can cause damage to internal components.

To remove battery pack, locate latches on end of battery pack and depress to release battery pack from your light.

BATTERY

DEPRESSLATCHESTO

 

RELEASEBATTERYPACK

Fig. 1

2

Page 2
Image 2
Craftsman 975815 Charging Your Worklight, To INSTALL/REMOVE Battery Pack, Battery Depresslatchesto Releasebatterypack